Haier AF09AS1ERA Operation Manual

Also see for AF18AS1ERA: Operation manual

Indoor Unit InstallaionDriverƽ Torque wrenchƽ(17mm,22mm,26mm)NipperƽReamerƽHacksawƽ Pipe cutterƽGas leakage detector orƽsoap-and-water solutionHole core drillƽ Flaring toolƽSpanner(17,19 and 26mm)ƽ KnifeƽMeasuring tapeƽNecessary Tools for Installation Power SourceBefore inserting power into receptacle, check the voltagewithout fail.The power supply is the same as the correspondingnameplate.Install an exclusive branch circuit of the power.A receptacle shall be set up in a distance where the powercable can be reached.Do not extend the cable by cutting it.Selection of Installation PlacePlace, robust not causing vibration, where the body canbe supported suf¿ciently.ƽPlace, not affected by heat or steam generated in thevicinity, where inlet and outlet of the unit are not disturbed.ƽPlace, possible to drain easily, where piping can beconnected with the outdoor unit.ƽPlace, where cold air can be spread in a room entirely.ƽPlace, nearby a power receptacle, with enough spacearound.ƽPlace where the distance of more than lm fromtelevisions, radios, wireless apparatuses andÀuorescent lamps can be left.ƽIn the case of ¿xing the remote controller on a wall,place where the indoor unit can receive signals when theÀuorescentƽlamps in the room are lightened.ƽƽƽRemote controller (1)R-03 dry battery (2)Mounting plate (1)Drain hose (1)Ø4X25 Screw (4)Plastic cap (4)Accessory PartsFOR 09K 12KFOR 18KSelection of PipeDrawing for the installation of indoor unitsƽAir purifying filter(Optional) (1)more than 10cmmore than cmmore than 10cm20more than 60 cmAttention must be paid tothe rising up of drain hoseThe models adopt HFC free refrigerant R410AArrangement of pipingdirectionsRear leftLeft RearrightRightBelow5