Haier AP88NACBEA Operation Manual

Also see for AP88NACBEA: Service manual

Haier AP88NACBEA Operation Manual Manual pdf 4 page image

Name of Parts Wire Controller14.Network control displayUsed to adjust thetime of timer andclockWhen the wirecontroller appearsabnormal condition,use a sharp-pointedarticle to press thisbutton to make thewire controllerresume normalAfter cleaning theair inlet, press thisbutton, the unitcan start to operate12.Humidifying state displayUsed to turn on/off unit1.ON/OFF button6.Air filter cleaning display*7.Super/Soft operation display13.Sleep state display2.Temperature display24.Time Adjustingbutton23.Sleep buttonUsed to set Sleepstate or PowerFailure ResumeFunctionWhen there is too much dustcollected on the air inlet, thewire controller will showthis display to remind theuser to clean the air inlet.After cleaning and installation,just press the air filter reset button.8.Fan speed display9.Auto Swing display11.Fresh air state display25.Reset button26.Air Filter Resetbutton27.Timer buttonUsed to set themode of timer29.Lock state display28.Electric heating button4.Timer ON/OFF display3.Clock display17.Operation mode button5.Humidity display22.Setting buttonUsed to confirmthe time of timerand clock15.Working mode display21.Clock buttonUsed to calibrate the time oftimer and clock16.Electric heating displayUsed to set working mode:Auto, Cooling, Dehumidifying,Heating, Fan18.Fan speed buttonUsed to set fan speed: LowFan, Med Fan, High Fan, Auto20.Temperature Setting button10.Health state display Used to set temperature,temperature range: 16*~30*19.Swing buttonUsed to set Auto Swing orFixed air sending directionNote:1.This model does not have the following related display and function2.Non-electric heating type, there is no electric heating button and electric heatingdisplay* * 10 11 1228166AutoLow Fan Med Fan High Fan AutoWorkingmode Autooperation Coolingoperation Dehumidifyingoperation Heatingoperation FanoperationWirecontrollerCalibration of clockWhen turning on the unit for the first time, the clock should be calibrated. Themethod of calibration is:1.Press ì Clockî button, the Clock display ì AMî ì PMî will flash.2.Press * or to adjust time. For each press, the time will increase or decrease 1*minute. If depressing the button, the time will increase or decrease rapidly.3.After confirming the time, press ì Setî button, ì AMî or ì PMî will stop flashing,*the clock will begin to work.*SETROOMAUTO293MODE FAN SWINGTEMPCLOCKTIMERSETSLEEPFILTER RESETRESETON/OFFHEAT