Indoor Unit InstallaionDriverƽ Torque wrenchƽ(17mm,22mm,26mm)NipperƽReamerƽHacksawƽ Pipe cutterƽGas leakage detector orƽsoap-and-water solutionHole core drillƽ Flaring toolƽSpanner(17,19 and 26mm)ƽ KnifeƽMeasuring tapeƽNecessary Tools for Installation Power SourceBefore inserting power into receptacle, check the voltage withoutfail.The power supply is the same as the corresponding nameplate.Install an exclusive branch circuit of the power.A receptacle shall be set up in a distance where the power cablecan be reached.Do not extend the cable by cutting it.Selection of Installation PlacePlace, robust not causing vibration, where the body can besupported sufficiently.ƽPlace, not affected by heat or steam generated in the vicinity,where inlet and outlet of the unit are not disturbed.ƽPlace, possible to drain easily, where piping can be conne-cted with the outdoor unit.ƽPlace, where cold air can be spread in a room entirely.ƽPlace, nearby a power receptacle, with enough space around.ƽPlace where the distance of more than lm from televisions,radios, wireless apparatuses and fluorescent lamps can beleft.ƽIn the case of fixing the remote controller on a wall, placewhere the indoor unit can receive signals when the fluore-scentƽlamps in the room are lightened.ƽƽƽThe distance between the indoor unit and the floor should be more than 2m.The models adopt HFC free refrigerant R410Amore than10cmmore than 15 cmmore than 10cmArrangement of pipingdirectionsRear leftLeft RearrightRightBelowAttention must be paid tothe rising up of drain hoseRemote controller (1)R-03 dry battery (2)Mounting plate (1)Drain hose (1)Ø4X25 Screw (4)Plastic cap (4)Accessory PartsFOR 07K 09K 12KFOR 18KFOR 24KSelection of PipeDrawing for the installation of indoor unitsƽAir purifying filter(Optional) (1)Please be subject to the actual product purchased,the above picture is just for your reference.15