Haier AU242FHBHA Installation Manual

Also see for AU242FHBHA: Service manual Installation manual

195 Corresponding saturation temperature of sensor Pd7 Opening of outdoor unit PMV1 (decimal number):( )(decimal number)( )(decimal number)Notice: Value Pd in cooling mode as well as value Pd in heating mode is of no consequence in AU362FIAIA model.SV2 hand setting of outdoor unit PMV2 of AU362FIAIA: Open: FF, Closed: 00SW01 SW02460123891011112131420123456789910114567891011Indoor unit capacity (Pi): NEW CODE : 0 denote 0.8(pi) ; 1 denote 1(pi) ; 2 denote 1.2(pi)Saturation temperature ( ) of indoor unit (Decimal number) : -26.0~67.0Sensor temperature ( ) of indoor unit TA (Decimal number): -26.0~67.0Sensor temperature ( ) of indoor unit TC2 (Decimal number): -26.0~100.0Sensor temperature ( ) of indoor unit TC1 (Decimal number): -26.0~100.0Display of numeral pipe with seven segmentsSensor TD Air Discharge value ( )(decimal number):Sensor TA Environment timP. value ( )(decimal number):Sensor TS Air suction value ( ) (decimal number):Sensor TE Defrost value ( )(decimal number):Sensor TC middle part of Condenser value ( )(decimal number):Corresponding saturation temperature of sensor Ps(Model AU362FIAIA don't have).Magnet valve SV2: ON: Non 0 OFF: 0On position of 2-way valve SV1 display ON: -1, OFF: --Current value of compressor when operating(decimal number)Blower fan mode of outdoor Low speed: -1 Medium speed:-2 High speed:-3Status of temperature sensor: ON: -1, OFF: --On position of 4-way valve display: ON: -1, OFF: --Force setting of operating mode status: Cooling: -C Heating: -HNo usedOpening hand setting of outdoor unit PMV1: All open: FF, All closed: 00Opening hand setting of outdoor unit PMV2: All open: FF, All closed: 00Rated operation setting: Rated operation: -F, Common: --Communicating status of indoor unit: Normal signal receiving: -1, Abnormal signal receiving: --Check code of indoor unit: No check code of indoor unit: --Required capacity of indoor unit (Decimal number): indoor P-CODEOpening of indoor unit PMV (Decimal number):Check fault in the electrical circuit Cooling operation:CC (old code have no)Check fault in the electrical circuit Heating operation: HH (old code have no)unification trial run of cooling operation: C (old code have no)unification trial run of heating operation: H (old code have no)unification trial run of auto operation: _F (old code have no)All open/close :open 11/close 00 (after three minutes display-- )(old code have no this function)Function of clean abnormity CL(old code have no)0-78Opening hand setting of outdoor unit PMV: All open and All closed function All open: FFDisplay amount of the indoor units ,display 6 denote have six indoor units :30-150-153 denote 1.5(pi) ; 4 denote 2(pi) ; 5 denote 2.5(pi)6 denote 3(pi) ; 7 denote 4(pi) ;OLD CODE : 1 denote 1(pi) ; 7 denote 7(pi)12130-150-150-151-161-161-161-161-16Single unit cooling operation trial runSingle unit heating operation trial runcalculate according to the compressor suction pressure(PS).Others and Test Run