Multi-Media Player SystemMulti-media player preparation1. Supported equipment1)Equipment supporting Mass Storage agreements include USB, mobile hard disk, cardreader, some MP3 and digital camera.2)Equipment supporting PTP agreements include some digital cameras.2. 1 Supporting media:picture, music, MPEG4, MPEG2 and MPEG1;Supporting file formats*.Avi, *.DIVX, *.MPEG,*.DAT, *.MP3, *.WHA, *.JPG and *.JPEG. Due to particularity of filecode and file format, It is possible that some files may not be read.2 If Pic & Music mode is activated, relative media file format will include JPEG and MP3 files.After Picture is selected, MP3 files set for play will open both music and picture files for syncplay performance. As some files are read while music is being played, the response of pictureoperation response might be affected.3.Before starting to operation, verify USB storage device is of FAT32 and FAT file systemformat. At present, this television does not support NTFS and the file systems of other format.4.Many movie files use suffix of AVI and MPG. However, many kinds of format are used forinternal files. This television can only play some AVI and MPG files of this format. Those fileswith suffix of dat are not movie files, expect data files used by computers, and cannot be playedfor movies.5.External card reader supports most digital cards available in the market. Readable digitalcards are classified according to the property of card readers and can be connected to mobilehard disks (working voltage 5.0V, working current not over 500mA).6. Sometimes the television operation may be halted due to excessive rate of information codeerrors. In such case, restart the system. Because there are many non-standard USB mobiledevices in the market. If this kind of USB mobile devices are used in the Multi-media playsystem, the problem of identification failure might occur. The same problem may also happenwith computers, not televisions.7.It is suggested that the external devices with USB2.0 interface be used to improve velocity ofinformation reading and continuity of information playing.CARD setup1.Insert USB in the USB slots at the right side the TV.2.Insert it to be clicked in.3.Press USB button on the remote controller to enter the Multi-media system.USB setupThis TV is Compatible with the card of SD/MMC/CF/MS/SM format.1.Jack of card InstructionsJack of SM cardJacks of SD MMC MS cardJack of CF cardJack 1Jack 2How to useNote1.Please note chooses uses the digital memory card with you corresponds the receptacle.2.Card reader in 1 cannot simultaneously insert two kind of cards in the graphical representationposition