Haier EK Series Service Manual

IntroductionDomestic Air ConditionerWarningBe sure to use an exclusive power circuit for the equipment, and follow the technical standards related tothe electrical equipment, the internal wiring regulations and the instruction manual for installation whenconducting electrical work.Insufficient power circuit capacity and improper electrical work can cause an electrical shock or fire.Be sure to use the specified cable to connect between the indoor and outdoor units. Make theconnections securely and route the cable properly so that there is no force pulling the cable at theconnection terminals.Improper connections can cause excessive heat generation or fire.When connecting the cable between the indoor and outdoor units, make sure that the terminal cover doesnot lift off or dismount because of the cable.If the cover is not mounted properly, the terminal connection section can cause an electrical shock,excessive heat generation or fire.Do not damage or modify the power cable.Damaged or modified power cable can cause an electrical shock or fire. Placing heavy items on thepower cable, and heating or pulling the power cable can damage the cable.Do not mix air or gas other than the specified refrigerant (R-410A / R22) in the refrigerant system.If air enters the refrigerating system, an excessively high pressure results, causing equipment damageand injury.If the refrigerant gas leaks, be sure to locate the leak and repair it before charging the refrigerant. Aftercharging refrigerant, make sure that there is no refrigerant leak.If the leak cannot be located and the repair work must be stopped, be sure to perform pump-down andclose the service valve, to prevent the refrigerant gas from leaking into the room. The refrigerant gas itselfis harmless, but it can generate toxic gases when it contacts flames, such as fan and other heaters,stoves and ranges.When replacing the coin battery in the remote controller, be sure to disposed of the old battery to preventchildren from swallowing it.If a child swallows the coin battery, see a doctor immediately.CautionInstallation of a leakage breaker is necessary in some cases depending on the conditions of theinstallation site, to prevent electrical shocks.Do not install the equipment in a place where there is a possibility of combustible gas leaks.If a combustible gas leaks and remains around the unit, it can cause a fire.Be sure to install the packing and seal on the installation frame properly. If the packing and seal are notinstalled properly, water can enter the room and wet the furniture and floor.Forintegralunits only4+6818HEK03Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html