Haier GE NS16AS Installation Instructions Manual

Also see for GE NS16AS: Service manual

507043-04G / 31-5000666Page 1 of 18Issue 2112(P) 507043-04G*P507043-04G*GE AppliancesA Haier CompanyAppliance ParkLouisville, KY 40225This manual must be left with the homeowner for future reference.Table of ContentsGeneral ........................................................................1Installation ...................................................................2Refrigeration Piping .....................................................3Electrical Wiring .........................................................12Start-Up .....................................................................13Maintenance ..............................................................14Homeowner Information ............................................15This is a safety alert symbol and should never be ignored. When you see this symbol on labels or in manuals, be alert tothe potential for personal injury or death.Installation and servicing of air conditioning equipmentcan be hazardous due to internal refrigerant pressureand live electrical components. Only trained andqualified service personnel should install or servicethis equipment. Installation and service performed byunqualified persons can result in property damage,personal injury, or death.WARNINGELECTRICAL SHOCK HAZARD!Risk of electrical shock. Disconnect allremote power supplies before installingor servicing any portion of the system.Failure to disconnect power suppliescan result in property damage, personalinjury, or death.WARNINGSharp metal edges can cause injury. When installingthe unit, use care to avoid sharp edges.WARNINGGeneralRead this entire instruction manual, as well as theinstructions supplied in separate equipment, beforestarting the installation. Observe and follow all warnings,cautions, instructional labels, and tags. Failure to complywith these instructions could result in an unsafe conditionand/or premature component failure.These instructions are intended as a general guide onlyfor use by qualified personnel and do not supersede anynational or local codes in any way. The installation mustcomply with all provincial, state, and local codes as well asthe National Electrical Code (U.S.) or Canadian ElectricalCode (Canada). Compliance should be determined priorto installation.This unit uses R-410A, which is an ozone-friendly HFCrefrigerant. The unit must be installed with a matchingindoor coil and line set. A filter drier approved for use withR-410A is installed in the unit.INSTALLATION INSTRUCTIONSNS16AS Single Stage Air Conditioner