Haier H2SM- - annexe 13 Operation Manual

Also see for 2HUM14H03/R2(DB): Installation manual Operation manual

Contents

Just press TIMER button several times until TIMERde disappears.According to the Time setting sequence of TIMER ONor TIMER OFF, either Start-Stop or Stop-Start can beachieved.Set clock correctly before starting TIMER operation.1. After unit starts, select your desired operation modeOperation mode will be displayed on LCD.2. Timer mode selectionPress TIMER button to change TIMER mode. Every timethe button is pressed, display changes as follows:Remote controller:Then select your desired TIMER mode (TIMER ON - OFF)." "will flash.3.Time settingPress HOUR button.Every time the button is pressed, time setting increases1 min, if kept depressed, it will increase rapidly.Every time the button is pressed, time setting decreases1 min, if kept depressed, it will decrease rapidly.It can be adjusted within 24 hours.4.Timer confirming for TIMER ONAfter setting correct time, press TIMER button to confirm" " on the remote controller stops flashing." " starts flashing.Time displayed: Unit starts or stops at x hour x min.5.Time setting for TIMER OFF6.Time confirming for TIMER OFFTo cancel TIMER modeJust press HOUR button ,follow the same procedure in"Time setting for TIMER ON"After time setting,press SET button to confirm." " on the remote controller stops blinking.Time displayed:Unit stops at x hour x min.17OperationTimer On-Off OperationRemote ControllerPOWER/SOFTFRESHBLANKTIMER ON TIMER OFF TIMER ON-OFF