Haier H2SM- - annexe 4 Operating Manual

Also see for H2SM-: Operating manual Operation manual Operating manual Operation manual Operation manual

Parts and FunctionsRemote controller7. SIGNAL SENDING display8. TIMER OFF display9. TIMER ON display10. CLOCK display11. TEMP display19. POWER ON/OFFUsed for unit start and stop.21. MODEUsed to select AUTO run, COOL, DRY and FAN operation22. HOURUsed to set clock and timer setting.14. SWINGUsed to set auto fan direction.23. SLEEPUsed to select sleep mode.18. LOCKUsed to lock buttons and LCD display.20. TEMP.Used to select your desired temp.17. SETUsed to confirm timer and clock settings.15. TIMERUsed to select TIMER ON, TIMER OFF,TIMER ON-OFF16. CLOCKUsed to set correct time24. RESETnormal condition.Used to reset the controller back to12. HEALTHUsed to operate the healthy functionDisplay board2525. Singal receiver hole26. Ambient temp.displayWhen receiving the remote control signal, display the settemperature and in the rest time the room temperature isdisplayed and this room temperature is only for reference.26 413. FANUsed to select fan speed LO, MED, HI, AUTO1 8 91 511. Operation mode display2. SWING display3. FAN SPEED display LO MED HIAUTO5. SLEEP display6. LOCK display4. HEA LTH displayOperation mode AUTO FANCOOL DRYRemote controllerDisplay boardHEATNOTE: Cooling only unit do not have displays and functions related with heatingClock setWhen unit is started for the first time and after replacing batteries in remote controller,clock should be adjusted as follows:Press CLOCK button, "AM" or "PM" flashes.Press or to set correct time. Each press will increase or decrease 1min. If thebutton is kept depressed, time will change quickly.After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clockstarts working.HintsAfter replacing with new batteries, remote controller will conduct self-check, displayingall information on LCD. Then, it will become normal.5678910192021222341231112131415161718 24ON/OFFMODESETFANTIMERSWINGCLOCKSLEEPLOCK RESETHEALTH6