H2SM-(9+12)HEK03/R2 Funcitions and ControlDomestic Air Conditioner12State1State2State3Ts-1 Ts Ts+2 Ts+25.1.4 Indoor Fan Control&RROLQJUXQPRGHDXWRZKHQ7U7V&WKHZLQGVSHHGLVKLJK :KHQ7V&7U7VWKHZLQGVSHHGLVPHGLXPWhen Tr Ts+1 , the wind speed is low.When temperature sensor is off, the fan motor runs at low speed.When the wind speed changes from low to high, there is no delay, and when it changes from highto low, there is a 3-minutes delay before conversion.Manual operation:When unit is on the wind speed can be set to high, medium, low or automatic asrequired (execute instruction 2 seconds later after receiving remote signal)+HDWLQJUXQPRGHManual operation: The wind speed can be set to high, medium, low or automatic as required.Automatic operation: When Tr :KHQ7V7U7V&WKHZLQGVSHHGLVPHGLXP :KHQ7V&7UWKHZLQGVSHHGLVORZ5.1.4.3 Warm start:When heating running begins, indoor fan will conduct the following fan control: ,IWKHWHPSHUDWXUHRILQGRRUFRLOSLSHLV&VWDUWORZHUZLQGVSHHG ,IWKHWHPSHUDWXUHRILQGRRUFRLOSLSHLV&WXUQWRVHWWLQJZLQGVSHHG&RQWURORILQGRRUIDQXQGHUKHDWLQJ2))VWDWH 8QGHUKHDWLQJVWDWHWKHFRPSUHVVRUZLOOFHDVHLIWKHLQGRRUFRLOSLSH¶VWHPSHUDWXUH7S&indoor fan will run in lower wind speed ; if the coil pipe’s temperature Tp<21°C ,indoor fan will cease.5.1.5 3minutes stand-by timeWhen the compressor ceases due to the sensor OFF, unit On or OFF or fault, it will maintain pausefor 3 minutes.5.1.6 Compensatory function of power failureIf the unit is suddenly off during running due to power failure, or closed for maintenance or troubleshooting,it will restart to run after the power resumes with the original condition before the unit is off.Note:1. Function setting: Pressing the SLEEP button on the remote control unit for 10 times until hearing 4sounds from the buzzer on the panel.2. 0HPRU\FRQWHQW5XQQLQJPRGHVHWWLQJZLQGVSHHGVHWWLQJWHPSHUDWXUHVOHHSVWDWHÀDSVWDWH