Haier H2SM-(9+12)HRA03/R2 Operation Manual

Also see for H2SM-(9+12)HRA03/R2: Installation manual

Contents

Haier H2SM-(9+12)HRA03/R2 Operation Manual Manual pdf 16 page image

Press MODE button. For each press, operation11Operation(1) Unit startmode changes as follows:Press ON/OFF button, unit starts.Previous operation status appears on display. (Not Timer setting)(2) Select operation modeUnit will run in operation mode displayed on LCD.Stop display at your desired mode.(3) Select temp. settingPress TEMP button.Every time the button is pressed, temp. setting increases 1oCEvery time the button is pressed, temp. setting decreases 1oCUnit will start running to reach the temp. setting on LCD.Press FAN button. For each press, fan speed changes(4) Fan speed selectionas follows:AUTO LO MED HIjust press ON/OFF button and unit will run in previous status.Unit runs at the speed displayed on LCD.HintsOn cooling only unit, heating mode is not available.Remote controller can memorize each operation status. When starting it next time,COOL operation starts when roomtemp. is higher than temp. setting. Ultra-low air flowTemp. setting+2oCTemp. settingOn reaching temp. setting, unitwill run in mild DRY mode.In DRY mode, when room temperature becomeslower than temp.setting+2oC,unit will run intermittentlyat LOW speed regardless of FAN setting.(5) Unit stopPress ON/OFF button, the unit stops.Dry OperationAUTO COOL DRY FANHEATNo reelecting is needed.(TIMER ON/OFF、SLEEP、SWING needs reelecting)ON/OFFMODESETFANTIMERSWINGCLOCKSLEEPLOCK RESETHEALTH331524