OperationDry OperationRemote controller1. Unit startLink with electronic power.Press ON/OFF on the remote controller, unit starts.The liquid crystal will display the working state of lasttime (Except Timer, Sleep, Power/Soft and Healthairflow).2.Select operation modePress FAN button. For each press, fan speed changes asfollows:Press MODE button. For each press, operation modechanges as follows:Remote controller:Remote controller:Then Select DRY operationPress TEMP. buttonEvery time the button is pressed, temp.settingincrease 1 C,if kept depressed, it will increaserapidlyEvery time the button is pressed, temp.settingincrease 1 C,if kept depressed, it will decreaserapidlySelect a desired temperature.4.Fan speed selection3.Select temp.setting5.Unit stopAir conditioner is running under displayed wind speedIn DRY mode, when room temperature becomes 2OChigher than temp.setting,unit will run intermittently atLOW speed regardless of FAN setting.Press ON/OFF button, the unit stops.COOL operation starts when roomtemp.is higher than temp.setting.On reaching temp.setting +2oCunit will run in mild DRY mode.Ultra-low air flowTemp.setting+2oCTemp.settingAUTOLOW MED HI AUTOCOOL DRY FAN HEAT11