Haier HBU-14CL03R1 Service Manual

Also see for AB142ACNAC: Operation manual

Haier HBU-14CL03R1 Service Manual Manual pdf 24 page image

5.3.7 WiringTerminal blockClip ACover of control box 1Rubber tube AGrounding leadCover of control box 2Terminal blockConnect withoutdoor unitOutInField wiringAttach seal padDon't fail to seal it, or, water may come in.Rubber tube Note: Have it sealed, leaving no space.Seal pad (small size)( )(Wind around wire)12•All supplied parts. materials and wiring operation must in appliance with local code and regulations.Use copper wire only.When make wiring, please refer to wiring diagram also.All wiring work must be done by qualified electricians.A circuit breaker must be installed, which can cut power supply to all system.See Installation Manual of outdoor unit for specifications of wires, circuit breaker, switches and wiring etc.Connecting of unitRemove cover of switch box (1) , drag wires into rubber tube A, then, after proper wiring with other wires,tighten clamp A. Connect wires of correct pole to the terminal block inside.Wind seal (12) around wires. (Be sure to do that, or, dew may occur).Upon connecting, replace control box cover (1) and (2).Obscrve the following when connecting power supply terminal block:Don't connect wires of different specifications to the sameterminal block.(Loose wire may cause overheating of circuit)Connect wires of same specifications as shown in right Fig.Connect wires of the samespecifications at two sides.Don't connect wires of thesame specifications at one side.Don't connect wires of thedifferent specifications.<<WARNING>>5.3.8 Wiring exampleAs for outdoor unit circuit, please see Installation Manual of outdoor unit.Note: All electric wires have their own poles, poles must match that on terminal block.5.3.9 Installation of ornament panel1. Prepare ornament panelHandling of ornament panelOrnament panel shall not be placed face down or against wall, neither on an uneven object.Don' t bend carelessly the swing flap, or, problem may occur.(1) Remove air inlet grill from ornament panel:Push in the bar on inlet grill and lift it up. (Refer to Fig. 1)Lift it up for about 45 degree and remove it from ornament.Tear off adhesive tape fixing air filter on the back of the airinlet grill. (Refer to Fig. 2)Cautions for the installationBe sure to show customers Operation Manual and guide them how to operate unit correctly. Before installation, read alsothe Installation Manual of indoor unit.With this ornament , 2 or 3 air flow direction is not available. Suitable height is 3 m.2Accessory Pad Pad1Bar- 23 -INSTALLATION INSTRUCTIONS