Haier HL22F2 Service Manual

Also see for HL22F2: Owner's manual Troubleshooting guide

Haier HL22F2 Service Manual Manual pdf 20 page image

19Service ManualModel No.: HL22F2aConnection Option 1Set VCR output switch to channel 3 or 4 and then tunethe TV to the same channel number.Connection Option 2Connect the audio and video cables from the VCR’sA output jacks to the TV input jacks, as shown in thefigure. When connecting the TV to VCR, match thejack colors (Video = yellow, Audio Left = white, andAudio Right = red). If you connect a S-VIDEO outputfrom VCR to the S-VIDEO input, the picture quality isimproved; compared to connecting a regular VCR tothe Video input.Insert a video tape into the VCR and pressB PLAY onthe VCR. (Refer to the VCR owner’s manual.)Select the input source with using theC INPUT buttonon the remote control, and then press /buttonto select the source, press ENTER button to confirm.A/V Source SetupConnect the audio and video cables from theAexternal equipment’s output jacks to the TV inputjacks, as shown in the figure.When connecting the TV to external equipment,Bwhite, and Audio Right = red).VIDEOAV INAUDIO OUTL RL -AUDIO- RHow to useSelect the input source with using theA INPUTon the remote control.Operate the corresponding external equipment.B Refer to external equipment operating guide.Component SetupHow to connectConnect the DVD video outputs (COMPONENT) toA the Y Pb Pr jacks on the TV and connect the DVDaudio outputs to the YPbPr Audio IN jacks on the TV,as shown in the figure.If your DVD only has an S-VIDEO output jack, connectB this to the S-VIDEO input on the TV, as shown in thefigure.NoteIf your DVD player does not haveRcomponent video output, use S-Video.COMPONENTINY Pb Pr L -AUDIO- RHow to useTurn on the DVD player, insert a DVD disc.AUseB INPUT button on the remote control to selectproper input.Connecting a computerHow to connectTo get the best picture quality, adjust the VGAA graphics card to 1024s768.Use the TV’s VGA or DVI (Digital Visual Interface)BAudio IN port for audio connections, depending onyour computer connector.If the graphic card on the computer does notqoutput analog and digital RGB simultaneously,connect only one of either VGA IN or HDMI IN todisplay the VGA on the TV.If the graphic card on the computer does outputqanalog and digital RGB simultaneously, set the TVto either VGA or HDMI; (the other mode is set toPlug and Play automatically by the TV.)Then, make the corresponding audio connection.CIf using a sound card, adjust the VGA sound asrequired.PC/DVI AUDIO IN PC IN9*$ ,1