Safety InstructionsFCC STATEMENTThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of theFCC Rule. These limits are designed to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, use and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications. However there is noguarantee that interference will not occur in particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encourage totry to correct the interference by one or more of the following measures:*Reorient or relocate the receiving antenna.*Increase the separation between the equipment and receiver.*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.*Consult the dealer or an experienced radiolTV technician for help.This device compiles with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may be not cause harmful interference.(2) this device must accept any interference received, including interference that may cause undesiredoperation.FCC CAUTION:To assure continued compliance and possible undesirable interference, the provided ferrite cores must beused when connecting this LCD display to video equipment; and maintain at least 40cm spacing to otherperipheral device.CANADIAN NOTICE:This Class B digital apparatus compiles with Canadian ICES-003.Energy Star compliant(models - HL26R1, HL32R1, HL26K1, HL32K1, HL32XK1)By being Energy Star compliant you are assured that your Haler model is helping the environment by using lessenergy while saving you money. ENERGY STAR is a joint program of the U.S. Environmental Protection Agency andthe U.S. Department of Energy promoting energy efficiency.Owner's Manual 3