InstallationHaier LED HDTV/DVD EN-8Choose Your ConnectionThere are several ways to connect your television,depending on the components you want to connectand the quality of the signal you want to achieve. Thefollowing are examples of some different ways toconnect your TV with different input sources.Connecting a VCRTo avoid picture noise (interference), leave an adequatedistance between the VCR and TV.VCRVIDEOAV INAUDIO OUTL RL -AUDIO- R ANT INConnection Option 1Set VCR output switch to channel 3 or 4 and then tunethe TV to the same channel number.Connection Option 2Connect the audio and video cables from the VCR’sAoutput jacks to the TV input jacks, as shown in thefigure. When connecting the TV to VCR, match thejack colors (Video = yellow, Audio Left = white,and Audio Right = red). compared to connecting aregular VCR to the Video input.Insert a video tape into the VCR and pressB PLAY onthe VCR. (Refer to the VCR owner’s manual.)Select the input source with using theC INPUT buttonon the remote control, and then press /buttonto select the source, press ENTER button to confirm.External A/V Source SetupHow to connectConnect the audio and video cables from theAexternal equipment’s output jacks to the TV inputjacks, as shown in the figure.When connecting the TV to external equipment,B match the jack colors (Video = yellow, Audio Left =white, and Audio Right = red).VIDEOAV INAUDIO OUTL RL -AUDIO- RHow to useSelect the input source with using theA INPUT buttonon the remote control.Operate the corresponding external equipment.BRefer to external equipment operating guide.Component SetupHow to connectConnect the DVD video outputs (COMPONENT) to theY Pb Pr jacks on the TV and connect the DVD audiooutputs to the YPbPr Audio IN jacks on the TV, as shownin the figure.COMPONENTINY Pb Pr L -AUDIO- RHow to useTurn on the DVD player, insert a DVD disc.AUseB INPUT button on the remote control to selectproper input.