Haier HPR09XC7 User Manual

Also see for HPR09XC7: User manual

Contents

O P E RATION (Only HPR09XH7)Indication symbols on LCD :o>_r< Cooling mode _= Highfanspeedamd_ Dehumidifymode _ MedfanspeedFan only mode _ Low fan speedHeating mode88 F Display set temperatureWarning lightthe machine will stop running_ 88hl- Display tirner setting of auto switch on/offPower ControlThe power control turns the unit on and off.Warning Light &Condensed water may accumulate in the unit. Ifthe internal tank becomes full, the Warning signalin the LCD Display will light up and the unit willnot operate until the unit has been drained.Mode ControlThe Mode Control has 4 settings:e Cool • Dehumidify e Fan ® HeatingThe settings are adjusted with Mode Controlbutton. A light will indicate which setting iscurrently being used.o Cooling ModeWhen cool mode is selected, "_i_" will show in theLCD Display, During the cooling mode the air iscooled and hot air is exhausted to the outsidethrough the exhaust tube. Adjust fan speed andair temperature to suit your desired comfort level,Note : The air exchange hoses must ventoutside the room when using cool mode,• Dehumidify ModeWhen Dehumidify mode is selected, "all" will showin the LCD Display. Air is dehumidified as it passesthrough the unit, without being in full cooling mode.If room temperature is higher than 25 degreeCelsius fan speed can be adjusted; otherwise fanspeed is fixed to " Low".Note:If the unit is to be used as adehumidifier, do not connect the exhaust hoselet the warm air return to the room.Continuous drainage is then necessary.• Fan ModeWhen fan mode is selected, "._ ", "_" or "_" will beshown in the LCD Display, Air is circulated throughoutthe room with no cooling.Note: unit does not need to be vented in Fan mode• Heating ModeWhen heating mode is selected, "O" will show in theLCD Display. Heating is activated only when theambient temperature is below 27°C. In this mode, thedesired temperature can be set between 16 and 27°C.Note: When the device is in heating mode, both airhoses must be connected and led outside.Fan Speed ControlThe Fan Speed Control has 3 settings: High,Medium, and Low.TimerAuto turn off:With machine in running mode, press timer button forsetting timer control. Press "_" or"_'" to select numberof hours you would like the unit to run before itautomatically shuts off.Auto turn on :With machine in stand by mode, press timer button forsetting timer control. Press "A" or"T'" to select numberof hours before the unit automatically starts running inairconditioning mode.Note:The time is adjustable between 1-24 hours.Temperature controls• Used for adjusting the thermostat.® The default display is room temperature.• in cooling mode, when " A "or " V " button is pressed,the set temperature is displayed and may be adjusted.After 15 seconds the display will revert back to roomtemperature. Temperature is only adjustable in cool mode.Note : By pressing both " A "/ " Y " buttons at thesame time for more than 3 seconds, the display willtoggle between Celsius and Fahrenheit,After switching the air conditioner off, you must wait 3 minutes before switching it back on again.=5-