Haier HSU-07HEA03 - annexe 1 Installation Manual

Also see for HSU-07HEA03 - annexe 1: Installation manual Installation manual Operation manual Installation manual Installation manual

Contents

Haier HSU-07HEA03 - annexe 1 Installation Manual Manual pdf 4 page image

Indoor unitFixing the indoor unit body[Other direction piping]Indoor/outdoor electric cable and drain hose must be bound with refrigerant piping by protecting tape.Cut away, with a nipper, the lid for piping according to the piping direction and then bend the pipe accordingto the position of wall hole. When bending, be careful not to crash pipes.Connect beforehand the indoor/outdoor electric cable, and then pull out the connected to the heat insulationof connecting part specially.Hang surely the unit body onto the upper notches of themounting plate. Move the body from side to side to verifyits secure fixing.In order to fix the body onto the mounting plate,hold upthe body aslant from the underside and then put it downperpendicularly.1. Insert the drain hose into the dent of heat insulation materials of indoor unit.2. Insert the indoor/outdoor electric cable from backside of indoor unit, and pull it out on the front side, thenconnect them.3. Coat the flaring seal face with refrigerant oil and connect pipes.Cover the connection part with heat insulation materials closely, and make sure fixing with adhesive tape4Heat insulationmaterialDrain hosePipingIndoor/outdoorelectric cableLid for right pipingLid for under pipingLid for left pipingFix with adhesive tapeEasily-demount cleaning of indoor unitInlet grille can be taken downmounting plateOpen the inlet grille,press the button of unlock in the left,then pushit out of the socket and take out the inlet grille.Unloading of indoor unit bodyWhen you unload the indoor unit,please use your hand to arisethe body to leave agraffe,then lift the bottom of the body outwardslightly and lift the unit aslant until it leaves the mounting plate.agraffemounting plate