Haier HSU-07HEK03 HSU-09HEK03 - annexe 1 Operation Manual

Also see for HSU-07HEK03 HSU-09HEK03 - annexe 1: Operation manual Installation manual Installation manual Manual Manual

Contents

Haier HSU-07HEK03 HSU-09HEK03 - annexe 1 Operation Manual Manual pdf 10 page image

(5) Unit stop(1) Unit startAuto,Cool，Dry,Heat and Fan operationPress ON/OFF button, unit starts.ON/OFFFANMODETIMERCLOCKSET SLEEPLOCK RESET1523 34SWINGOperationmode changes as follows:(2) Select operation modePress MODE button. For each press, operationUnit will run in selected mode.(4) FANPress FAN button. For each press, fan speed changesas follows:AUTO LO MED HIUnit will run at selected fan speed.Note:AUTO is not available in FAN mode.Press ON/OFF button.Note:Remote controller:2.In DRY mode, when room temperature becomes lower than temp.setting+2oC,unit will run intermittently at LOW speed regardless of FAN setting.When FAN is set to AUTO, the air conditioner automatically adjusts the fan speed accordingto room temperature.1.(3) Select temp. settingPress TEMP button.Every time the button is pressed, temp. setting increases 1oCEvery time the button is pressed, temp. setting decreases 1oCUnit will start running to reach the temp. setting on LCD.In FAN operation mode, the unit will not operate in COOL mode but only in FAN mode ,AUTO is not available in FAN mode.And temp.setting is disabled.In FAN mode,SLEEP operation is not available.3.AUTO COOL DRY FAN9HEATIn HE AT mode, warm air will blow out after a short period of the time due to cold-draftprevention function.When FAN is set to AUTO, the air conditioner automatically adjuststhe fan speed according to room temperature.4.just press ON/OFF button and unit will run in previous status.Remote controller can memorize each operation status. When starting it next time,5.