Haier HSU-07HV03 Operating Manual

Haier HSU-07HV03 Operating Manual Manual pdf 15 page image

Remove the batteries in case unit won't be in usage for a long period. If there are any displayafter taking-out, just need to press reset key.Parts and FunctionsClock SetWhen unit is started for the first time and after replacing batteries inremote controller, clock should be adjusted as follows:Remote controller's operation3. After time setting is confirmed, press SET, "AM" or "PM" stop flashing,while clock starts working.2. Press or to set correct time. Each press will increase or decrease1 min. If the button is kept depressed, time will change quickly.1. Press CLOCK button,"AM" or "PM" flashes.When in use, put the signal transmission head directly to the receiver hole on the indoor unit.The distance between the signal transmission head and the receiver hole should be within7m without any obstacle as well.Don't throw or knock the remoter controller.When electronic-started type fluorescent lamp or change-over type fluorescent lamp orwireless telephone is installed in the room, the receiver is apt to be disturbed in receivingthe signals, so the distance to the indoor unit should be shorter.Loading of the batteryLoad the batteries as illustrated right2 R-03 (7#) batteriesRemove the battery cover:Slightly press" "area and push down the coveras illustrated.Load the battery:Be sure that the loading is in line with the "+" / "-".request as illustrated on the bottom of the case.Put on the cover again.Confirmation indicator:After pressing power ON/OFF, if no display, reload the batteries.Note:Full display or unclear display during operation indicates the batteries have been used up.Please change batteries.Used two new same-typed batteries when loading.If the remote controller can't run normally during operation, please remove the batteries andreload several minutes later.Hint:8