Haier HSU-07LEK113 Operation Manual

Also see for HSU-07HEK113: Installation manual

Contents

3OperationSleep Operationwind speed is high or middle before setting for thesleep, set for lowing the wind speed after sleeping.If it is low wind, no change.5.Set the wind speed change when sleeping If theUse of SLEEP functionOperation Mode1. In COOL,DRY modeSLEEP operation starts SLEEP operation stopsSLEEPoperation startsSLEEPoperation stopsApprox.6hrs1 hr1 hr1 hr3 hrs3 hrsRises 1 OCRises 1 OCRises 1 OCTemp.settingTemp.settingUnit stopUnit stopIn COOL, DRY modeIn HEAT modeDecreases 2O CDecreases 2O C1 hr2.3.In HEAT modeIn AUTO mode4. In FAN modeIt has no SLEEP function.NoteWhen TIMER function is set, the sleeping function can'tbe set up .After the sleeping function is set up ,if userresets TIMER function, the sleeping function will becancelled;the machine will be in the state of timing-on.POWER/SOFT OperationBefore going to bed,you can simply press the SLEEPbutton and unit will operate in SLEEP mode and bringyou a sound sleep.After the unit starts,set the operation status,then press SLEEP button before which theclock must be adjusted and time being set.1 hours after SLEEP mode starts,temp.will become1℃ higher than temp.setting.After another 1 hours,temp.rises by 1℃ futher.The unit will run for further6 hours then stops Temp. is higher than temp.setting so that room temperature won’t be too lowfor your sleep.1 hours after SLEEP mode starts,temp will become2℃ lower than temp.setting.After another 1 hours,temp decrease by 2℃ futher.After more another3 hours,temp.rises by 1℃ futher.The unit will runfor further 3 hours then stops.Temp.is lower thantemp.setting so that room temperature won’t betoo high for your sleep.The unit operaters in corresponding sleep modeadapted to the automatically selected operation mode.(1) POWER Operation(2) SOFT OperationPress POWER/SOFT button again ,POWER or SOFTdisappears.To cancel POWER or SOFT operationNote ：When you need rapid heating or cooling, you can use thisfunction. In COOL mode, fan speed automatically takeshigh speed of AUTO fan mode. In HEAT mode, fan speedautomatically takes medial speed of AUTO fan mode.You can use this function when silence is needed forrest or reading. In SOFT operation mode, fan speedautomatically takes low speed of AUTO fan mode.During POWER operation, in rapid HEAT or COOLmode , the room will show inhomogeneous temperaturedistribution. Long period SOFT operation will causeeffect of not too cool or not too warm.(This function is unavailable on some models.)next time,just press ON/OFF button and unit will run in previous status.Remote controller can memorize each operation status. When starting itAir Flow Direction AdjustmentVertical flapPos.1 Pos.2 Pos.3Pos.4 Pos.5 (Auto swing)1.Status display of air flowWhen restart after remote turning off, the remotememorize the previousMove the vertical blade by a knob on airto adjust left and right direction referring to Fig.2.Left and right air flow adjustment(manual)Cautions:When adjusting the flap by hand,turn off the unit.When humidity is high,condensate water might occuradjusted to left orIt is advisable not to keep horizontal flap at downwardposition for a long time in COOLor DRYotherwise, condensate water might occur.conditionerat air outlet if all vertical louvers areright.mode ,controller will automaticallyNote:set swing position.