Haier HSU-09HEA103/R2 - annexe 1 Operation Manual

Also see for H2SM-(9+12)HEA03/R2: Installation manual Operation manual Operation manual Operation manual

Contents

Haier HSU-09HEA103/R2 - annexe 1 Operation Manual Manual pdf 4 page image

4OperationSleep OperationIf the wind speed is high or middle beforesetting for the sleep, set for lowing the windspeed after sleeping.If it is low wind, no change.5.Set the wind speed change when sleepingUse of SLEEP functionOperation Mode1. In COOL,DRY modeSLEEP operation starts SLEEP operation stopsSLEEPoperation startsSLEEPoperation stopsApprox.6hrs1 hr1 hr1 hr3 hrs3 hrsRises 1O CRises 1 OCRises 1 OCTemp.settingTemp.settingUnit stopUnit stopIn COOL, DRY modeIn HEAT modeDecreases 2O CDecreases 2O C1 hr2.3.In HEAT modeIn AUTO mode4. In FAN modeIt has no SLEEP function.NoteWhen TIMER function is set, the sleeping functioncan't be set up .After the sleeping function is set up ,if user resets TIMER function, the sleeping functionwill be cancelled;the machine will be in the state oftiming-on.POWER/SOFT Operation(1) POWER Operation(2) SOFT OperationTo cancel POWER or SOFT operationThe POWER / SOFT symbols on the remote controllwill be disappeared after 15 minutes, the unit continues torun according to the original state. Press POWER/SOFTbutton again, POWER or SOFT disappears.Note˖HEALTHY OperationHealthy Negative ionsBefore going to bed,you can simply press the SLEEPbutton and unit will operate in SLEEP mode and bringyou a sound sleep.After the unit starts,set the operation status,then press SLEEP button before which theclock must be adjusted and time being set.1 hours after SLEEP mode starts,temp.will become1 higher than temp.setting.After another 1 hours,temp.rises by 1 futher.The unit will run for further6 hours then stops Temp. is higher than temp.setting so that room temperature won’t be too lowfor your sleep.1 hours after SLEEP mode starts,temp willbecome 2 lower than temp.setting.Afteranother 1 hours,temp decrease by 2futher.After more another 3hours,temp.risesby 1 futher.The unit will run for further 3hours then stops.Temp.is lower than temp.setting so that room temperature won’t betoo high for your sleep.The unit operaters in corresponding sleep modeadapted to the automatically selected operationmode.The anion generator in the airconditioner cangenerate a lot of anion effectively balance thequantity of position and anion in the air and alsoto kill bacteria and speed up the dust sediment inthe room and finally clean the air in the room.During POWER operation, in rapid HEAT or COOL mode,the room will show inhomogeneous temperature distribution.During SOFT operation will cause effect of not too coolor not too warm.O C O COC OCO CWhen you need rapid heating or cooling, you can usethis function. In COOL mode, fan speed automaticallytakes high speed of AUTO fan mode. In HEAT mode,fan speed antomatically takes high speed of AUTOfan mode.You can use this function when silence is needed for restor reading. In SOFT operation mode, fan speedantomatically takes low speed of AUTO fan mode.