Haier HSU-09RR103/R2 - annexe 1 Operation Manual

Also see for HSU-09RR103-R2: Installation manual

Contents

Haier HSU-09RR103/R2 - annexe 1 Operation Manual Manual pdf 3 page image

3AUTO COOL DRY FAN HEAT2.Select operation modePress FAN button. For each press, fan speedfollows:Press MODE button. For each press, operation modechanges as follows:Remote controller:Remote controller:Press buttonEvery time the button is pressed, temp.settingincrease 1 oC,if kept depressed, it will increaserapidlyEvery time the button is pressed, temp.settingdecrease 1 o C,if kept depressed, it willdecrease rapidlySelect a desired temperature.4.Fan speed selection3.Select temp.settingAir conditioner is running under displayed fan speed.When FAN is set to AUTO, the air conditionerautomatically adjusts the fan speed according to roomtemperature.LOW MED HI AUTO1. Unit startPress ON/OFF on the remote controller, unit starts.Base OperationRemote controllerEmergency Operation:temperature is below 16 oC, do not use it in theTest operation:Use this switch in the test operation when the roomnormal operation.your finger from the switch: the coolingContinue to press the test operationswitch for more than 5 seconds . Afteryou hear the "Pi" sound twice, releaseTest ope ration switch is the same as emergency switch.operation starts with the air flow speed "Hi".Emergency operation and test operationUse this operation only when the remote controlleris defective or lost.When the emergency operation switch ispressed,the" Pi "sound is heard once, whichthe start of this operation.In this operation, the system automatically selectsthe operation modes,cooling or fan or heat,according to the room temperature..It is not possible to operate in dry mode.Roomtemperature Operationmode Designatedtemperature Timermode Air flowABOVE 23 OCBELOW 23OCCOOLINGHEAT 23O C26O C NONOAUTOMATICAUTOMATIC(C ooling only uint˅Room temperature Operationmode Designatedtemperature Timermode Air flowBELOW 23OC FAN 26OC NO AUTOMATICPimeanschanges asUnit won't restart until 3 minutes have elapsed, due toHEAT mode is not available oncooling only unit.It is advisable not to keep vertical flap at downward positionor DRY mode, otherwise,water might occur.Cautions:When humidity is high, condensate water might occur atlouvers are adjusted to left or right.for a long time in COOLair outlet if all horizontalsystem protection.condensateVertical flapPos.1 Pos.2 Pos.3Pos.4 Pos.5 Pos.6 (Auto swing)1.Status display of air flow2.Left and right air flow adjustment(manual)Pos.1 Pos.2 Pos.3 Pos.4Pos.5 Pos.6 Pos.7 Pos.8For each press of button, remote controllerdisplays as follows :remote controller:OperationModeAUTODisplayBoardRemoteController NoteCOOLDRYHEATFAN nothingUnder the mode of auto operation, air conditioner willautomatically select Cool or Heat operation accordingto room temperature.air conditioner automatically adjusts the fan speedtemperature.When FAN is set to AUTO, theaccording to roomIn FAN operation mode, the unit will not operate inCOOL or HEAT mode but only in FAN mode ,AUTO isnot available in FAN mode.And temp.setting is disabled.In FAN mode,SLEEP operation is not available.OperationAir Flow Direction AdjustmentPiPi