Haier HSU-10HA03 - annexe 1 Operation Manual

Also see for AS102ALARA: Operation manual

Contents

Haier HSU-10HA03 - annexe 1 Operation Manual Manual pdf 14 page image

No DisplayStop at .At the state of Super Mode Operation ,when cooling, the temperature will be 4 lower thanthe temperature set, and the fan will automatically run at high speed for 15 minutes, then return tothe previously set state;when heating, the temperature will be 6 higher than the temperature set ,and the fan will automatically run at mid speed for 15 minutes, then return to the previously set state.Press the POWER button twice until thedisplay disappears.When you need silence, you can use this function.Press the POWER button each time the display willvary in the following sequence:Stop at .At this state, the fan speed is Low .Press POWER button once until the display disappears.Hints:When at the state of Super Mode Operation , the room temperature would not be even. And longtime soft mode operation would make the room temperature neither too cold nor too hot.Cancel Super Mode Operation:Soft Mode OperationSet the Soft Mode Operation:Cancel Soft Mode Operation:12OperationHEALTHTIMERTEMPON/OFFRESETSWINGCMODEAUTOPower Failure Resume (to be applied for a necessary situation) (only for the models:AS102ALARAAU102ACARA(HSU-10H03(DB)) AS122AVARA AU122ACARA(HSU-12H03(DB)) AS102AMARAAU102ACARA(HSU-10HA03(DB)) AS122AYARA AU122ACARA(HSU-12HA03(DB)))After the power failure compensation is set, if power failure suddenly occurs while the air conditioner isworking, it will resume the previous working state when the power is supplied again .When a power failure suddenly occurs during the air conditioner is working after the power failureresume is set, if the air conditioner will not be used for a long time, please cut off the power supply toprevent its operation from being resumed after the power is supplied again, or press the On/Offbutton after the power comes again.Notes:POWERFANWhen you need to cool or heat your room rapidly, you can use this function.Set Super Mode Operation :Press the POWER button each time the display will vary in the following sequence:No DisplaySuper Mode Operation Insufficient Cold Air or Hot AirInsufficient Cold Air?Cold Air is Blew out (during heating operation)Has the mode been selected correctly?Has the inlet or outlet been blocked?Is there any other hotresources in the room?Is the unit under heating operation?If, after the above-mentioned checks are made and treated accordingly, the air conditioner stillcannot work normally or one of the following facts are found, please stop the operation andcontact your local service center:Fuse or circuit breaker often breaks;Water is leaked during cooling and dehumidifying;Working abnormally or abnormal sound is heard.Is the sun light directly sentinto the room?Are there many people in theroom?Is the dust filter too dirty? (it should be cleanedonce every two weeks)Is the door or window open?21Trouble Shooting