Haier HSU-18HEA03/R2(DB)-I Service Manual

Also see for HSU-18HEA03/R2(DB)-I: Operating manual Operation manual

Haier HSU-18HEA03/R2(DB)-I Service Manual Manual pdf 49 page image

HSU-18HEA03/R2(DB)-I Introduction47Before going to bed, you can simply press theSLEEP button and unit will operate in SLEEPmode and bring you a sound sleep.Use of SLEEP functionAfter the unit starts, set the operation status,then press SLEEP button before which theclock must be adjusted and time being set.Operation Mode1. In COOL,DRY mode1 hours after SLEEP mode starts, temp. willbecome 1O C higher than temp. setting. Afteranother 1 hours, temp. rises by 1O C further.The unit will run for further 6 hours then stops.Temp. is higher than temp. setting so that roomtemperature won't be too Iow for your sleep.If the wind speed is high or middle beforesetting for the sleep, set for lowing the windspeed after sleeping.If it is low wind, no change.5.Set the wind speed change when sleepingIn COOL, DRY mode2.3.In HEAT mode1 hours after SLEEP mode starts, temp2 OC lower than temp. setting. After another 1 hours,decrease by 2 OC further. After more3 hours, temp. rises by 1O C further. The unit will runfor further 3 hours then stops. Temp. is lower thantemp. setting so that room temperaturehigh for your sleep.In AUTO modeThe unit operates in corresponding sleepmode adapted to the automatically selectedoperation mode.4. In FAN modeIt has no SLEEP function.OperationPOWER/SOFTSleep OperationRemote ControllerSLEEP operation starts SLEEP operation stopsApprox.6hrs1 hr Rises 1 OCRises 1 OCTemp.setting Unit stop1 hrSLEEPoperation startsSLEEPoperation stops1 hr1 hr3 hrs3 hrsRises 1 OCTemp.setting Unit stopIn HEAT modeDecreases 2O CDecreases 2O C6.Note to the power failure resume:press the sleep button ten times in five secondsand enter this function after hearing four sounds.And press the sleep button ten times within fiveseconds and leave this function after hearingtwo sounds.With the power failure resume, when settingthe TIMER ON, TIMER OFF and TIMER ON/OFF,it’s memorized as shutdown status when resumingafter power out.NOTE:will becometemp anotherwon't be too