Haier HSU-18LEB03 - annexe 1 Operation Manual

Also see for ASM30H03-N(T3): Operation manual Operation manual Operation manual Operation manual

Contents

Haier HSU-18LEB03 - annexe 1 Operation Manual Manual pdf 3 page image

2OperationUnit start / stopNote:In DRY mode,when room temperature becomes lower than temp.setting+2 C, unit will run intermittently at LOW speed regardless of FAN setting.In HEAT mode,warm air will blow out after a short periodof the timeWhen FAN is set to AUTO, the air conditioner automatically adjustsnext time,just press ON/OFF button and unit will run in previous status.Remote controller can memorize each operation status. When starting itCooling only unit do not have displays and functions related with heatingPress ON/OFF button, unit starts or stops.According to the automaticchoice system in temperaturein indoors cold or make theautomatically adjusts1.2.In FAN operation modeAuto OperationCool OperationHeat OperationDry OperationFan OperationWhen FAN is set to AUTO,the air conditionerthe fan speed accordingto room temperature.the unit will not operatein COOL mode but onlyin FAN mode ,AUTO is not available in FAN mode.And temp.setting is disabled.due to cold-draft prevention function.the fan speed according to room temperature.Note:Air Flow Direction AdjustmSelect temp.settinghot movement.Health airflow OperationThe setting of health airflow function1).Press the button of health airflow, appearson the display. Avoid the strong airflow blows2).Press the button of health airflow again,appears on the display. Avoid the strongNote:1 .After setting the health airflow function, the position of inlet and outlet grills is fixed.2.In heating, it is better to select the mode.3.In cooling, it is better to select the mode.4.In cooling and dry, using the air conditioner for a long time under the high air humidity,a phenomenon falling drips of water occurs at the outlet grille .5.Select the appropriate fan direction according to the actual conditions.direct to the body.strong airflow blows direct to the body.3.The cancel of the health airflow functionPress the button of health airflow again, both the inlet and outlet grills of theair conditioner are opened, and the unit goes on working under the conditionbefore the setting of health airflow function.After stopping, the outlet grille will close automatically.Notice: Cannot pull direct the outlet grille by hand. Otherwise,the grille will runincorrectly. If the grille is not run correctly,stop for a minute and then start,adjusting by remote controller.0Display Board RemoteController NoteCOOLDRYHEATFAN nothingIn DRY mode, when room temperature becomeslower than temp.setting+2 oC,unit will run intermittentlyat LOW speed regardless of FAN setting.Under the mode of auto operation, air conditioner willautomatically select Cool or Heat operation accordingto room temperature.air conditioner automatically adjusts the fan speedtemperature.When FAN is set to AUTO, theaccording to roomIn FAN operation mode, the unit will not operate inCOOL or HEAT mode but only in FAN mode ,AUTO isnot available in FAN mode.And temp.setting is disabled.In FAN mode,SLEEP operation is not available.OperationModeAUTOAUTO LO MED HIVertical flapPos.1Pos.2Pos.3Pos.4Pos.5Pos.6(Auto swing)Horizontal louversPos.1Pos.2Pos.3Pos.4Pos.5Pos.6Pos.7Pos.8(This function is unavailableon some models.)FRESHFRESH