Haier HSU09XHK-G Operation Manual

Contents

OperationAir Flow Direction AdjustmentBase Operation1.Status display of air flow2.Left and right air flow adjustment(manual)Cautions:When adjusting the flap by hand,turn off the unit.When humidity is high,condensate water might occuradjusted to left orIt is advisable not to keep horizontal flap at downwardposition for a long time in COOLor DRYotherwise, condensate water might occur.Emergency operation and test operationat air outlet if all vertical louvers areright.mode ,Note:test operationswitchEmergency Operation:Use this operation only when the remote controller is defectiveor lost, and with function of emergency running, air conditonercan run automatically for a while.When the emergency operation switch is pressed, the unitbeeps once, which means the start of this operation.When power switch is turning on for the first time andemergency operation starts, the unit will run automatically inthe following modes:emergencyoperation switchis below 60 o F, do not use it in the normal operation.Test operation:Use this switch in the test operation when the room temperaturefrom the switch: the cooling operationContinue to press the test operationswitch for more than 5 seconds.Afteryou hear two beeps, release your fingerstarts with the air flow speed "Hi".Under this operation mode,the fan motor of indoorunit will run in high speed.COOL/DRY:Test operation switch is the same as emergency switch.2Press FAN button. For each press, fan speedfollows:Remote controller:Press buttonSelect a desired temperature.4.Fan speed selection3.Select temp.settingAir conditioner is running under displayed fan speed.When FAN is set to AUTO, the air conditionerautomatically adjusts the fan speed according to roomtemperature.1. Unit startPress ON/OFF on the remote controller, unit starts.Remote controllerchanges asOperationModeRemoteController NoteUnder the mode of auto operation, air conditioner willautomatically select Cool or Heat operation according toroom temperature. When FAN is set to AUTO the airconditioner automatically adjusts the fan speed accordingto room temperature.In FAN operation mode , the unit will not operate in COOL orHEAT mode but only in FAN mode, AUTO is not available inFAN mode. And temp. setting is disabled. In FAN mode,sleep operation is not available.1433LOW MED HI AUTO2. Select operation mode2COOL button:Cooling modeHEAT button: Heating modeDRY button: Dehumidify modeDRYCOOLAUTOHEATFANIn HEAT mode, warm air will blow out after a shortperiod of the time due to cold-draft prevention function.When FAN is set to AUTO, the air conditioner automaticallyadjusts the fan speed according to room temperature.Roomtemperature DesignatedtemperatureTimermode FanspeedOperationmodeAbove 74 o FBelow 74o F 74 o F78o FNoAUTOAUTOCOOLHEATNoEvery time the button is pressed, temp.settingincrease 1 oC / 2 F, if kept depressed, it willincrease rapidlyEvery time the button is pressed, temp.settingdecrease 1 oC / 2 F, if kept depressed, it willdecrease rapidlyooAUTOWhen restarting the unit after it has been turned off,the unit will keep the swing position before it stopsworking.During emergency operation it is impossible to change thesettings of temp. and fan speed,It is also not possible tooperate in timer or dry mode.Move the vertical blade by a knob on airto adjust left and right direction to achievestereoscopic air flow as the figure below.conditionerstereoscopic air flowpeeBpeeB-peeBIn DRY mode , when room temperature is 2 C/4 F degreesoless than the temperature set point, the unit will runintermittently at LOW speed regardless of FAN setting.o