Operation1.After unit starts, select your desired operation mode.2.Press TIMER button to change TIMER mode. Everytime the button is pressed, display changes as follows:Remote controller:BLANKTIMER ON TIMER OFF TIMER ON-OFFThen select your desired TIMER mode (TIMER ON orTIMER OFF or TIMER ON-OFF). " "or " "will flash.3.Press / button to set time.It can be adjusted within 24 hours.Hints:After replacing batteries or a power failure happens, timesetting should be reset.According to the Time setting sequence of TIMER ON orTIMER OFF, either Start-Stop or Stop-Start can be achieved.Timer On/Off On-Off Operation Healthy Airflow Operation1.Press to startSetting for comfortable conditions.2.The setting of healthy airflow functionNote:1.After setting the healthy airflow function, the positionlouver is fixed.4.In cooling and dry, using the air conditioner for a longtime under the high air humidity, condensate water mayoccur at the grille .3.To cancel of the healthy airflow functionNotice: Do not direct the horizontal louver by hand. Thismay cause the louver to run incorrectly and not match thedisplay. If the louver is not running correctly, stop the unitfor a minute and then restart and adjust remotecontroller.2.In heating, it is better to select the3.In cooling, it is better to select themode.mode.TIMER OFF-ON0.5h 0.5h 0.5h 0.5hPress the button for each time, setting time in the first12 hours increased by 0.5 hour every time, after 12hours,increased by 1 hour every time.Press the button for each time, setting time in the first12 hours decreased by 0.5 hour every time, after 12hours,decreased by 1 hour every time.After adjusting the time,press button and confirmthe time the ON or OFF button will not flash any more.4.Confirm timer setting5.Cancel timer settingPress the timer button until the time display eliminated.Press button to enter additional options,Press thisbutton continuously, the louvers location will cycle betweenthe following three locations, to choose the swing locationwhat you want, then button to confirm.Press button to enter additional options,Press thisbutton continuously, the louvers location will cycle betweenthe three locations again, then button to cancel.HealthyairflowupwarderHealthyairflowdownwarderPresentposition4