Haier HW-09LM03 - annexe 1 Operation Manual

Also see for HW-09LM03: Operation manual Operation manual Operation manual User manual Operation manual

1234This switch controls the preset indoortemperature to make the air conditionerstart or stop automatically, so as to reducepower consumption and operate thesystem both comfortably and economi-cally.The compressor stops running when theset temperature is reached but the fancontinues to operate to keep an evenindoor temperature.Always turn off the air conditioner and the main power supply before clean the unit.Switch off the power supply if the unit is not going to be used for a long period of time.Note:It is advisable not to keep horizontal flap at downward position for a long time in COOLor FANmode,otherwise , condensate water might occur.Don't move the vertical flap with hand in order to avoid the vertical flap abnormal, using theAUTO SWING switch to adjust the move of vertical flap.Cleaning of theair filterAfter unit stops, don't restart ituntil 3 min. have elapsed.Don't be exposed to cold air fora long time.Avoid opening doors and windowsunless necessary.Use curtain or blindDirect sunlight may reduce coolingeffect, always use window curtain.Keep heat source away fromair conditioner.Set temp . a little bit higherbefore going to bed.OK! Enjoy a3-min napPropertemperaturePlease read this operation manual before using the air conditionerPlease keep it attentively0010517091OPERATION MANUALOPERATION CONDITIONSROOM AIR COMNDITIONERCONTENTSSafety precautions...................1Air conditioner operation..........2Care and Maintenance ............4Air conditioner installation........5Troubleshooting.......................7AIR CONDITIONER OPERATION2 CARE AND MAINTENANCE3SAFETY PRECAUTION1Operation panelIt is advisable to clean air filter every two weeks forlonger operation.(You will find how to clean the filter on page 2 .)Baby hasgone sleep,better to adjustsuitable temp.Don't hang clothes in the vicinityof air inlet. This will decreasecooling effect and cause abnormaloperation.Temperature should be set properlywhen there are infant,child, theaged or disabled in the room.Before operating modeselection switch, check that ifthe air inlet or outlet have beenblocked.CAUTIONMachine bodyFront panelAir inlet(indoor side)Air outlet(indoor side)Air inlet(outdoor side)OperationpanelAir filter (inside)Machine bodyPower plugTake out the air filterClean the filterHumpWhen dirt accumulates on air filter, aircirculation will be blocked, which causespoor cooling. It is advisable to clean airfilter every two weeks for longer operation.1.Press the concave parts onboth sides at the lower part ofair inlet grille to open the airinlet grille.2.Hold the hump of filter meshwith fingers (as illustrated) andtake it out.1.Gently flap the dirt off the air filter.2.Carefully wash air filter in warm water(below 40°C).Toobtain better cleaning effect,soap water or neutral detergentmay be used.3.Flush air filter carefully with clean water after removingdirt.Let it dry completely.PART INDENTIFICATIONOPENCLOSEThe ventilation lever must beCLOSE position in order tomaintain the best coolingconditions. When fresh air isnecessary in the room, set theventilation lever to the OPENposition. The damper isopened and room air isexhausted.Airflow Direction VaneThe horizontal air direction isadjusted by setting theAUTO SWING switch to theON position.The Vertical Airflow DirectionVane is manually controlledby positioning the vane todischarge the airupward,downward or straightout.Vertical airflow directionVentilationAir filter cleaning2 Airflow Direction3Ventilation1Do not raise the front panelany higher than 70° to theunit or damage to the tabsmay occur.CAUTIONBefore cleaning, turn offthe powerAir filter cleaning1Notes2Auto swing switch1Thermostat switch2Mode selection switch370 °Applicable ambient temperature range:Cooling Indoor OutdoorMax.Temperture:Min.Temperture:D.B D.BW.B W.B32 Co23 Co18 Co14 Co43 Co26 Co18 Co/ D.B :Dry Bulb TemperatureW.B :Wet Bulb TemperatureCAUTIONSwitch off the breaker and set the maincontrol knob to the off position beforeplugging the power plug into an electrialoutlet.In cooling mode, after you turnthermostat switch counter-clockwise,donot turn it back until at least 3 minuteshave elapsed.Otherwise, the fuse mayblow due to overload.Do not exceed the selection range.12345 678910Do not install,remove and reinstall the unit yourself. Improper installation may causeleakage,electric shock or fire.Please engage an authorized dealer or specialist for the installation work.The room air conditioner must be earthed.Do not touch or operate with wet hands.Do not turn on the unit by inserting the power plug.Do not switch off the unit by pulling outthe power plug.Do not insert sticks,fingers or other objects into the unit.If the supply cord is damaged, it must be replaced by the manufacturer or its service agentor a similar qualified person.After installation, the power plug should be easily reached.The wiring method should be in line with the local wiring standard.HW07M HW09MHW12M HW18MHW07M HW09M HW12M HW18M

/ 2

Related manuals for Haier HW-09LM03