Haier LCD19W-M3 User Manual

Haier LCD19W-M3 User Manual Manual pdf 10 page image

Connection InstructionsYou can use your LCD-TV as a monitor for your personal computer using a VGAcable (not supplied).VGA InputConnection and use steps:1.Read the user guide supplied withyour computer and ensure that it hasa VGA connector;2.Make sure that the power of the LCD-TV and the PC are off;3.Connect a D type 15-pin VGA interfacecable ( not supplied ) to the VGA videointerface connector on the PC. Thenconnect the other end to the PC videointerface connector on the back of theLCD-TV.Tighten the screws on the VGAconnectors once they are firmlyconnected, connect the audio cable(notsupplied)to the audio input on the back ofyour LCD-TV;4.Turn on the power of the LCD-TV first ,and then turn on the power of the PC;5.Press the SOURCE button to set the videoinput mode of the LCD-TV to PC;6.Check the image on your TV. There may be noise associated with the resolution,vertical pattern, contrast or brightness in PC mode. If noise is present, changethe PC mode to another resolution, change the refresh rate to another rate oradjust the brightness and contrast on the menu until the picture is clear. If therefresh rate of the PC graphic card cannot be changed,change the PC graphiccard or consult the manufacturer of the PC graphic card.Frame frequency (Hz)Line frequency (Khz)VGASVGAXGA640*480 31.5KHz 60Hz800*600 37.9KHz 60Hz1024*768 48.4KHz 60HzMode ResolutionNote: All above listed are subject to VESA Criteria.YPbPr InputHow to connectConnect the DVD video outputs (Y, PB, PR)to the COMPONENT(Y, Pb, Pr) IN socket onthe TV and connect the DVD audio outputsto the AUDIO IN jacks on the TV, as shownin the figure.NOTE: If your DVD player does not havecomponent video output, use S-Video.How to use1. Turn on the DVD player, insert a DVD.2. Use the SOURCE button on the remote control to selectVGA IN