Haier LE32N1620 Owner's Manual

Haier LE32N1620 Owner's Manual Manual pdf 16 page image

OperationEN-15 Haier LED HDTVOperationguided through an initial setup process. Please followthe instructions provided on the screen to complete thisprocess.There are several options in the system menu that youmay need to adjust in order for your TV to work properly.Please read the instructions that follow carefully.NoteThe drawings of the screen menus found in thison your TV. These drawings are for illustrativepurposes only and are intended to guide your TVoperation.Getting Started1 Connect the power cord to a wall outlet and thenpress Power to turn the TV on. The Power Indicatorturns on.2 Select the input source that you want to view bypressing the INPUT button on the remote control.3 When you are finished using the TV, press the POWERbutton on the remote control. The TV will return tostandby mode.4 If you will not use the TV for an extended period oftime, it is recommended to disconnect the powerplug from the wall power outlet.NoteWhen the TV is powered on, an on screen displaywill indicate the active input source for a fewmoments. If a signal is not detected at that input,"No Signal" will be displayed on the screen.Choose the menu languageSelect the language that will be used for displayingsystem menus and messages as part of the initial TVsetup.1 Choose the TV input and then press the MENUbutton.2 Press the/buttons to select the Functionmenu.3 Press the/ ENTER button and then use the/buttons to select Language.4 Press the/button to select a language(English, Español or Français).LockLanguage EnglishAspect Ratio NormalOSD Timeout LongDPMS OnCEC Setup MenuDCR OffEnter Move ExitVideoAudioChannelChoose the Input sourceChange the active input source to watch TV, or to watchother devices that are connected to your TV (e.g., VCR,DVD player, cable box).f Press the INPUT button once to see the Input Sourcedisplay. Continue to press the INPUT button untilthe input source that you want is active (e.g., HDMI1,Component, Video, VGA).Select the desired program1 Using the CH / buttons.Press the CH button to tune to a higher channel.Press the CH button to tune to a lower channel.2 You can also tune to a channel directly by enteringthe channel number using the number pad on theremote control and then pressing ENTER.NoteIf skip is set to ON for a channel, pressing theCH / buttons will not show the skippedchannel(s).Select the desired volume levelPress the VOL-/+ buttons on the remote or on the side ofthe TV set to adjust the volume level. The range is 0~100.When the volume buttons are pressed the volume levelis displayed automatically on the TV screen.If you plug in a USB or wifi, please wait for about 4seconds to power indication start blinking.