Haier LE50K6500DUA Owner's Manual

-12-TV OPERATIONPower supply to switch on/off this Unit.Before switch on, ensure that all connections will be properand correct.Press the Key at the bottom of the panel of thisUnit to turn on this Unit.Press the Key to show Menu andselect Power Logo to turn off this Unit.When the powerindicator turns red, this Unit accesses standby state.Basic OperationPress key to start this Unit.The power indicator turnsPress key once again to switch off this Unit.If there is no signal for the current signal source, this unit willautomatically set to the standby state minutes later.If not to use the main Unit for a long time, unplug the ACpower cord from the AC outlet.off.15Select input signal sourcesAfter turn on the main unit, press source to select proper inputsource. Press ▼/▲ button to select the main signal source.Press OK button to confirm.Setting the OSD MenuPress MENU button, and the main menu appears. the mainmenu display in turn as below:Picture→Sound→Channel→Lock→Time→SettingWhen display of some menu option is gray, it indicates thatsuch options are not available under the current mode.General Step for Menu Setup:For each main menu, first press OK button to enter thesubmenu. Press ▲/▼ button to select the desired adjustable option. Press ◀/▶ button to adjust to suitable value. After the selection of option is completed, press Menubutton to be able to quit the menu.Installation GuideThe installation guide only appear when the TV first time turnon or reset to factory set .Language SettingPress ▲/▼ button to navigate the menu and change thesettings. Select your desired language to be displayed onthe menu. Press ▶button to next.Input password and Press ▼ button to select Connect andthen press the OK button. Press ▶ button to next . If youwant to back ,press ◀ button.Auto ScanPress ◀/▶ button to select Country.Press ◀/▶ button to select Air / Cable.Press ◀/▶ button to select Analog / Digital.If set success , Select Start Scan button and Press OK button.Channel tuning will commence. This operation may takeup to some minutes. The display will show the progress ofthe tuning and the number of channels found.LOCK PasswordInput your password and press Confirm to complete.Note: The default password is 0000.Network SettingPress ▼/▲ button to select Wi-Fi and press the OK button.