Haier LE50K6500U Instruction Manual

Also see for LE50K6500U: Service manual

Contents

Trouble ShootingMy TV does not display the pictureon my laptop / PC when connected.Most PC's and laptops when connected with a VGA Plug (theblue 15 pin plug on your PC or laptop) require you to presssome buttons on your key board to get a picture on a TV orother external display. This is usually the F7 (Dell) or F4 (HP /Samsung) or F5 (Toshiba). On laptops, you have to press the“Fn” key at the same time as the “F” key.I have connected my PC/Laptop tothe TV and get a picture but nosound. Why ?The VGA cable only carries the video or picture information.You need to connect a separate cable connected to theearphone socket (3.5mm jack) on you PC/Laptop to the 3.5m(PC Audio IN) socket on your TV. You will need to select “PC”using the Source button on your remote.Alternatively connect your PC/Laptop using a HDMI cable ifyou PC/Laptop has a HDMI connector. HDMI is both audio andvideo.The picture is not auto resizingwhen changing channels.Check that the TV picture Aspect Ratio is set to 'Auto' on allinputs ATV, DTV, SCART, HDMI 1, 2 etc.To set the aspect ratio, (Auto, 4:3 or 16:9). Press Source buttonstart at ATV and repeat the sequence below for all inputsources ATV, DTV, SCART, HDMI 1 and 2 as each input source iscontrolled separately.Press TV Menu buttonPress Right Arrow to access Picture sub menuPress Down Arrow to select Aspect RatioSelect AutoPress ExitRepeat for all input sources.I have just plugged in a DVD playeror another item into my TV and itdoesn't work.This is applicable to any item of equipment plugged to the TV1. Turn both TV & DVD player off (plugs out of the wall socket,not standby).2. Turn off any equipment connected to the SCART socket.3. Disconnect the SCART plug from the TV.4. Plug in and turn TV on5. Plug in and turn DVD player on6. Select HDMI from Source Menu7. Press play on DVD player and check movie plays okNOTE: The SCART socket has priority over HDMI and it isimportant that the equipment connected to the SCART socketon the TV is switched OFF (not in standby).Please follow this information. If the advice works and theDVD player works, the TV is OK it is just a bit confused.Probably HDMI plugs have been removed and plugged back inwhen the TV is switched on.Never remove or plug in HDMI cables or any digital equipmentwith the equipment switched on.Always switch off all equipment when unplugging orconnecting any digital equipment.Trouble ShootingEN-21