Haier QBJ1-130A58E Instructions For Use Manual

Contents

Haier QBJ1-130A58E Instructions For Use Manual Manual pdf 9 page image

Assembly InstructionGlass tube assembly1. Keep tubes out of the irradiation while assembling the unit or a scald may becaused.2. Place the rounded side of rubber seal downwards on the open end of tubes.(A)3. Insert the tube into base support of locating hole with gentle pressure and twistingmotion.4. Holding the tube, fix base support into base bracket (B), insert tube into basesupport (C).5. Slide the tube down 1 cm, Slide black rubber seal up the tubes until it sits flushwith tank(D).6. Insert one tube on either end of the tank to achieve alignment of unit.Notice:1. Make sure the silicon seal ring are clean and well positioned.2. Place the rounded side of rubber seal downwards on open end of tube.Slide it down 10 cm. Wet open end of tube to make it easier to insert.6Silicon seal ringRubber sealEvacuated tubesEvacuatedtubesRubber sealhold positionBase supportBase supportBase bracketBase bracketA CB D