Hameg HM 2005 Manual
                                    | |
Contents
| 
33Subject to change without noticeThe only ways to quit this status are: Switching the oscilloscope off,transmitting the command RM= 0 from the PC to the oscilloscope, or depressing the AUTOSET ( LOCAL ) pushbutton,if in unlocked condition (command LK=1... was not sent)After the remote state has been switched off the RM -LED (3) isdark.Please note:A minimum time must elapse between the commandsRM=1... (remote on) and RM=0... (remote off) and viceversa. The time can be calculated with the formula:tmin = 2x(1/baud rate) + 60μs.If at the beginning no SPACE CR command is recognizable, theoscilloscope pulls the TxD line low for approx. 0.2ms and causesa break on the PC.Data CommunicationAfter successfully being set to remote control mode, theoscilloscope is prepared for command reception.RS-232 Interface |
Related manuals for Hameg HM 2005
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine