1 - 12{4} lists this symbol's Mask Pattern and Error Correction Level.{5} lists the numbers of Data and Check Words and their arrangement intoblocks.{6} presents an approximate X-dimension.Note: The reported X-dimension is approximate and based upon use of the4410LR at 4.7 in (12 cm) (see "Reading Techniques" on page 1-1). If youuse different image engines, the X-dimension will vary. If you hold thereader closer than 4.7 in (12 cm), it will have the effect of reporting a largerthan true X-dimension. Conversely, if you hold the reader farther awaythan 4.7 in (12 cm), it will have the effect of reporting a smaller than trueX-dimension. Please contact Hand Held Products Application Support foradditional information. Refer to Chapter 3 for contact information.{7} lists the Data Safety Margin. "M" is the recommended error correctionlevel for QR Code, so symbols encoded at "H" or "Q" will typically havesafety margins exceeding 100%, while those encoded at "L" are limited tovalues below 50%.{8} and {9} list the Horizontal & Vertical Print Growths, respectively.MaxiCodeThe Full Report from a typical scan looks like the following (line numbers havebeen added in curly brackets):{1} This is a representative Maxicode symbol{2} >>> PQA from Hand Held Products <<<{3} MAXICODE: Mode 4{4} X roughly = 0.043"{5} [A] < Data Safety Margin = 100%{6} [A] < Horizontal Print Growth = +2% of X{7} [A] < Vertical Print Growth = -1% of X{1} is the Encoded Message.{2} is the Banner heading.{3} identifies the Symbology (MAXICODE) and lists the symbol's Mode.{4} presents an approximate X-dimension.Note: The reported X-dimension is approximate and based upon use of the4410LR at 4.7 in (12 cm) (see "Reading Techniques" on page 1-1). If youuse different image engines, the X-dimension will vary. If you hold thereader closer than 4.7 in (12 cm), it will have the effect of reporting a larger