Hand Held Products 7400/7450 User Manual

Contents

Hand Held Products 7400/7450 User Manual Manual pdf 12 page image

1 - 4FCC ComplianceDolphin 7400/7450 Batch TerminalThe Dolphin 7400/7450 Batch complies with part 15 of the FCC rules. Operation is subject to the following two conditions:1. Devices may not cause harmful interference.2. Devices must accept any interference received, including interference that may cause undesired operation.Dolphin 7400/7450 RF Terminal with Cisco® 352 or Spectrum24® (LA 3021) RadioThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may notcause harmful interference, and (2)this device must accept any interference received, including interference that may causeundesired operation.In accordance with FCC 15.21, changes or modifications not expressly approved by the party responsible for compliance couldvoid the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radioor television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The usermay find the following booklet helpful: "Something About Interference." This is available at FCC local regional offices. Ourcompany is not responsible for any radio or television interference caused by unauthorized modifications of this equipment or thesubstitution or attachment of connecting cables and equipment other than those specified by our company. The correction willbe the responsibility of the user. Use only shielded data cables with this system.In accordance with FCC 15.21, changes or modifications not expressly approved by the party responsible for compliance couldvoid the user’s authority to operate the equipment.CAUTION: To comply with FCC RF exposure compliance requirements, a separation distance of at least 2 inches (5 cm)must be maintained between the antenna of this device and all persons (excluding hands, wrists, feet and ankles),during normal operation.This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.This device is not specified or designed for body-worn configurations. Use of any body-worn accessories may notensure compliance with the FCC RF exposure guidelines.Canadian ComplianceThis Class B digital apparatus complies with Canadian ICES-003.Operation is subject to the following two conditions: 1. Devices may not cause harmful interference. 2. Devices must accept anyinterference received, including interference that may cause undesired operation. To prevent radio interference to the licensedservice, this device is intended tobe operated indoors and away from windows to provide maximum shielding. Equipment (or itstransmit antenna) that is installed outdoors is subject to licensing.Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.