Hand Held Products SCANTEAM 2070 Quick Start Manual

Also see for IMAGETEAM 3870: System manual

Contents

Cordless Scanning System Quick Start 5IMAGETEAM 3875You may automatically discharge the IT3875 charge pack by scanning thefollowing bar code. The scanner remains operational during the discharge;however the status LED flashes like a “heartbeat.”Associating the Cordless Scanner to a BaseImportant: Make sure the cordless scanner’s charge pack has been fullycharged. See page 3 for charging instructions.Using the cordless scanner, scan the Association Bar Code (the bar code labelon the top of the base) to link that scanner to the base.Two quick beeps followed by clicking, then a single beep indicates a “good”association. The scanner is in communication with the base. If the scannerclicks for 30 seconds and signals an error (triple beep), it has not associated withthe base.Note: If the charge pack is removed from the scanner and replaced afterassociation, the scanner automatically reassociates to the base if thebase has power. In this case, the scanner beeps when a charged chargepack is installed, then beeps a second time after full association, typicallyfive to ten seconds later.Note: A scanner always defaults to work group 0 after scanning a base I.D. barcode.Sample codes have been included in the back of this Quick Start Guide. Scan abar code to make sure that your scanner is working correctly after you havecharged the charge pack and associated the scanner with a base.IT3875 Charge Pack Discharge