7 - 30 Rev C Dolphin® 9500 Series User’s GuideInstalling Certificates with CertAddCertificate RequirementsDuring configuration, you may have specified one or two certificates to use during the authentication process. The specifiedidentity should match the Issued to field in the certificate and should be registered on the authentication server (i.e., RADIUSserver) that is used by the authenticator. In addition, your certificate must be valid on the authentication server. This requirementdepends on the authentication server and generally means that the authentication server must know the issuer of your certificateas a trusted Certificate Authority (CA).If the selected certificate does require a password or pass phrase to decode the private key, enter this value in the “CertificatePass Phrase” field. This value will be encrypted when the configuration is saved. However, on some systems, there may not bea certificate. If that is the case, you can use the section below as a primer on OS X certificate management.About CertAddCertAdd is a standalone utility that allows certificates to be selected and installed on a Windows Mobile device.Installing CertificatesClient or CA certificates can be imported from *.cer (same as *.der), *.p7b, or *.pfx files.1. Download the certificate file to the My Documents folder. The location isn’t critical, although you may want to create astandard folder for consistency.2. Go to Start > Programs > Meetinghouse Certificate Installer. The opening screen is displayed. All valid certificate filetypes located in the My Documents folder appear in the list.3. Tap and hold on a certificate in the list. A pop-up appears asking if you want to install the certificate.4. Tap OK. The certificate is loaded into the correct certificate store.Advice and WorkaroundsIssue Possible Causes and SolutionsThe Client will not start on the device with anerror message about missing files. Perform a soft reset.The wireless network interface (port) does notappear in the main AEGIS screen.• The license is not valid (If you have entered a time-limited license, isyour clock on the device correct?).• Restart the client - on the main screen tap Client > Restart.• Perform a soft reset.• If the radio is turned off or the radio card is not present, this willsometimes cause the port name to not appear.• If the radio driver is very old and does not support NDIS 5.1commands, the Client may not be able to detect it.
