Hans Grohe AXOR Starck Series Instructions For Use/assembly Instructions

Also see for AXOR Uno2: Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use/assembly instructions

Contents

installation instructions

Hans Grohe AXOR Starck Series Instructions For Use/assembly Instructions Manual pdf 4 page image

4 Assembly see page 32Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The product may not be used as a holding handle. Aseparate handle must be installed.The hot and cold supplies must be of equal pres-sures.Installation Instructions• Prior to installation, inspect the product for transportdamages. After it has been installed, no transport orsurface damage will be honoured.• The pipes and the fixture must be installed, flushedand tested as per the applicable standards.• The plumbing codes applicable in the respectivecountries must be observed.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 70°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 min10418000 / 10477000 / 34427000 / 38427000 /39457000: Safety against backflowThe product is exclusively designed for drinking water!EnglishTest certificate (see page 40)Spare parts (see page 38)Symbol descriptionMaintenance (see page 36)10418000 / 10477000 / 34427000 /38427000 / 39457000:The safety device must be checked regularlyaccording to DIN EN 1717 in accordancewith national or regional regulations (at leastonce a year).Fault Cause RemedyMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective - Exchange cartridgeHot water temperature too low, nocold water. Instantaneous waterheater starts up when cold water isselected.- Hot water limiter incorrectly set - Set hot water limiter- Crossflow - Exchange cartridgeDiverter not operating - Residue - Clean converter / grease O-rings- Water pressure to low - Increase water pressure- Diverter defective - Exchange diverterDo not use silicone containing acetic acid!Adjustment (see page 34)To adjust the hot water limiter. Using a hotwater limiter in combination with a continu-ous flow water heater is not recommended.Dimensions (see page 31)Flow diagram (see page 31)Rate of flow by 0,3 MPa: Shower outlet Tub outletOperation (see page 35)Cleaning (see enclosed brochure)