Hans Grohe Ecostat Comfort 13118000 Instructions For Use/assembly Instructions
Also see for Ecostat Comfort 13118000: Instructions for use/assembly instructionsInstructions for use/assembly instructionsInstructions for use/assembly instructionsInstructions for use/assembly instructions
                            |
Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The shower system may only be used for bathing,hygienic and body cleansing purposes.Children as well as adults with physical, mental and/or sensoric impairments must not use this showersystem without proper supervision. Persons underthe influence of alcohol or drugs are prohibited fromusing this shower system.The hot and cold supplies must be of equal pres-sures.Installation Instructions• Prior to installation, inspect the product for transportdamages. After it has been installed, no transport orsurface damage will be honoured.• The product is not designed to be used with steambaths!• The fitting must be installed, flushed and tested afterthe valid norms!• The plumbing codes applicable in the respectivecountries must be oberserved.ECOSTAT in conjunction with flow heat-ers• If fitting a hand shower remove the water limiter fromthe shower.• 13118000 / 13119000: In case of problems with thecontinuous water heater or of greatly varying waterpressures, you must install the water limiter (comprisedin the delivery, article number 97510000) in the coldwater supply.EnglishMaintenance (see page 21)• To guarantee the smooth running of thethermostat, it is necessary from time totime to turn the thermostat from total hotto total cold.• The mixer is equipped with check valves.The check valves must be checkedregularly according to DIN EN 1717 inaccordance with national or regionalregulations (at least once a year).Safety Function (see page 18)The desired maximum temperature for exam-ple max. 42º C can be pre-set thanks to thesafety function.Adjustment (see page 17)After the installation, the output tempera-ture of the thermostat must be checked. Acorrection is necessary if the temperaturemeasured at the output differs from thetemperature set on the thermostat.Do not use silicone containing acetic acid!Symbol descriptionTechnical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 – 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 min• Safety against backflow• The product is exclusively designed for drinking water!4 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine