Hans Grohe Ecostat Comfort HQ 13112000 Instructions For Use/assembly Instructions

Also see for Ecostat Comfort 13114000: Instructions for use Instructions for use/assembly instructions Instructions for use Instructions for use/assembly instructions

Assembly see page 60Fault Cause RemedyInsufficient water - Supply pressure inadequate - Check water pressure (If a pumphas been installed check to see ifthe pump is working).- Filters are dirty (96922000) - Clean filter in front of the mixerand on the MTC-thermo cartridge(96922000)- Shower filter seal dirty - Clean filter seal between showerand hoseCrossflow, hot water being forcedinto cold water pipe, or vice versa,when mixer is closed- Backflow preventers dirty or leak-ing- Clean backflow preventers, ex-change if necessarySpout temperature does notcorrespond with temperature set- Thermostat has not been adjusted - Adjust thermostat- Hot water temperature too low - Increase hot water temperature to42 ºC to 65 ºCTemperature regulation not possible - Thermo cartridge calcified - Exchange thermo cartridgeShower or spout dripping - Dirt or sedimentation on valve seat,shut-off unit damaged- Clean or exchange shut-off unitInstantaneous heater didn't workwith thermostat- Non return valve hasn't movedback- Exchange non return valves- Flow limiter in handshower isn’tremoved- Remove flow limiter- Filters are dirty - Clean the filter / exchange filterTest certificate (see page 72)Spare parts (see page 68)Flow diagram(see page 66)c Showerd Bath tubDimensions (see page 66)Operation (see page 64)English7