Hans Grohe Ecostat Select 13111000 Instructions For Use/assembly Instructions

Also see for Ecostat Select 13111000: Instructions for use/assembly instructions

4 Assembly see page 32Fault Cause RemedyInsufficient water - Supply pressure inadequate - Check water pressure (If a pump has been installedcheck to see if the pump is working).- Regulator filter dirty - Clean filter in front of the mixer and on the MTC-thermo cartridge- Shower filter seal dirty - Clean filter seal between shower and hoseCrossflow, hot water being forced into cold water pipe,or vice versa, when mixer is closed- Backflow preventers dirty or leaking - Clean backflow preventers, exchange if necessarySpout temperature does not correspond with tempera-ture set- Thermostat has not been adjusted - Adjust thermostat- Hot water temperature too low - Increase hot water temperature to 42 ºC to 65 ºCTemperature regulation not possible - thermo cartridge calcified - Exchange thermo cartridge- Dirt or sedimentation on valve seat, shut-off unit dam-aged- Clean or exchange shut-off unitInstantaneous heater didn't work with thermostat - Filters are dirty - Clean the filter / exchange filter- check valve hasn't moved back - Exchange check valves- Flow limiter in handshower isn’t removed - Remove flow limiter- Ecostop safety set removed. - Remove Ecostop safety set (#95771000)Cleaningsee enclosed brochure.Flow diagram (see page 31) Shower outlet 1BDimensions (see page 31)Operation (see page 36)Maintenance (see page 35)The check valves must be checked regularly according to DIN EN1717 in accordance with national or regional regulations (at least oncea year). To guarantee the smooth running of the thermostat, it is neces-sary from time to time to turn the thermostat from total hot to total cold.Adjustment (see page 33)After the installation, the output temperature of the thermostat must bechecked. A correction is necessary if the temperature measured at theoutput differs from the temperature set on the thermostat.Safety Function (see page 34)The desired maximum temperature for example max. 42º C can be pre-set thanks to the safety function.Do not use silicone containing acetic acid!Symbol descriptionSafety NotesGloves should be worn during installation to prevent crushing and cuttinginjuries.Children as well as adults with physical, mental and/or sensoric impairmentsmust not use this product without proper supervision. Persons under the influ-ence of alcohol or drugs are prohibited from using this product.The product may not be used as a holding handle. A separate handle must beinstalled.The shower system may only be used for bathing, hygienic and body cleaningpurposes.The hot and cold supplies must be of equal pressures.Installation Instructions• Prior to installation, inspect the product for transport damages. After it has beeninstalled, no transport or surface damage will be honoured.• The pipes and the fixture must be installed, flushed and tested as per the applica-ble standards.• The plumbing codes applicable in the respective countries must be oberserved.• The product is not designed to be used with steam baths!Thermostatic mixer in conjunction with combination boilers• If fitting a hand shower remove the water limiter from the shower.• Thermostatic mixer Shower: To ensure smooth operation, we recommend toremove the ECOSTOP washer disk (#95771000) when using a flow heater withhydraulic control.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CCentre distance: 150±12mmConnections G 1/2: cold right - hot leftThermal disinfection: max. 70°C / 4 minSafety against backflowThe product is exclusively designed for drinking water!EnglishSpare parts (see page 36)ECOSTOP (see page 33)Test certificate (see page 31)