Hans Grohe Elegance 33802000 Manual

Also see for Elegance 33802000: Assembly instructions

7EnglishAttention! The fitting must be installed, flushed andtested after the valid norms.Assembly1. Flush through the supply pipes.2. Place the mixer including the sealing washer inposition on the sink.3. Slip the plastic washer, the slide washer, themetall washer and collar nut over the hoseand threaded base and tighten the collar nutby hand. If there is not enough space, pleaseuse only the slide washer and the metall withoutthe plastic washer.4. Tighten screws.5. Connect the connecting hose to the angle valves;cold right - hot left.Large differences in pressure between the hot andcold water supply should be balanced.OperationThe mixer is actuated by lifting the lever head.Swivel to the left = hot water,swivel to the right = cold water.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPaHot water temperature: max. 80° CRecommended hot water temp.: 65° CRate of flow: 11 l/min 0,3 MPaHansgrohe single lever mixers can be used togetherwith hydraulically and thermically controlledcontinuous flow heaters if the flow pressure is atleast 0,15 MPa.To adjust the hot water limiter on single lever mixers,please see page 17.No adjustment is necessary when using a continuousflow water heater.Spare parts (see page 3 + 4)1 lever head 338910001.1 screw cover 963380002 flange 963910003 nut 941940004 cartridge cpl. 927300005 aerator cpl. 139130006 fixation cpl. 950490007 connection hose 600 mm 3/8" 965100008 connection hose 600 mm 140990009 ELASTOP stop unit 9484900010 seal 9500800011 sealing set 96529000