Hans Grohe Focus 100 Instructions For Use Manual

Also see for Focus: Assembly instructions Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use/assembly instructions

Contents

4EnglishAssembly (see page 32)Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The product may only be used for bathing, hygienicand body cleaning purposes.The hot and cold supplies must be of equalpressures.Installation Instructions• Prior to installation, inspect the product for transportdamages. After it has been installed, no transport orsurface damage will be honoured.• The pipes and the fixture must be installed, flushedand tested as per the applicable standards.• The plumbing codes applicable in the respectivecountries must be observed.• The drain valve must only be used as intended. It isnot allowed to attach other objects to the drainvalve, for example a semi-pedestal.• If the instantaneous water heater causes problemsor if you wish to increase the water flow, theEcoSmart® (flow limiter) located behind the aeratorcan be removed.Technical DataThis mixer series-produced with EcoSmart®(flow limiter)Operating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 70°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 minThe product is exclusively designed for drinking water!Symbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 34)To adjust the hot water limiter. Using a hot water limiterin combination with a continuous flow water heater isnot recommended.Dimensions (see page 35)Flow diagram (see page 38) with EcoSmart® without EcoSmart®Spare parts (see page 40)Special accessories (order as an extra)• special tool #58085000 (see page 32)• Installation putty (see page 33)• seal #98996000 (see page 32)Cleaning (see page 43)Operation (see page 39)• Hansgrohe recommends not to use as drinking waterthe first half liter of water drawn in the morning orafter a prolonged period of non-use.• After periods of prolonged non-use, but at leastevery third day, the fittings must be opened with thehandle in hot and cold position to prevent stagnationin the connecting lines. Let the water run until thewater temperature is constant.Test certificate (see page 48)