Hans Grohe Metris 110 31084010 Instructions For Use/assembly Instructions

Also see for Metris 110 31084010: Instructions for use/assembly instructions

4EnglishAssembly (see page 6)Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The product may only be used for bathing, hygienicand body cleaning purposes.The hot and cold supplies must be of equalpressures.Installation Instructions• Prior to installation, inspect the product for transportdamages. After it has been installed, no transport orsurface damage will be honoured.• The pipes and the fixture must be installed, flushedand tested as per the applicable standards.• The plumbing codes applicable in the respectivecountries must be observed.• 31082010: If the instantaneous water heatercauses problems or if you wish to increase the waterflow, the EcoSmart® (flow limiter) located behind theaerator can be removed.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 70°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 minThe product is exclusively designed for drinking water!Symbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 8)To adjust the hot water limiter. Using a hot water limiterin combination with a continuous flow water heater isnot recommended.Dimensions (see page 9)Flow diagram (see page 9)Spare parts (see page 10)Cleaning (see page 12)Operation (see page 7)Hansgrohe recommends not to use as drinking waterthe first half liter of water drawn in the morning or aftera prolonged period of non-use.