Hans Grohe Metris 110 Series Instructions For Use/assembly Instructions

Also see for 31121000: Instructions for use/assembly instructions Instructions for use Instructions for use/assembly instructions Assembly instructions

Contents

installation instructions

Hans Grohe Metris 110 Series Instructions For Use/assembly Instructions Manual pdf 2 page image

Assembly see page 31Test certificate (see page 40)Cleaning(see enclosed brochure)Operation (see page 35)• Hansgrohe recommends not to useas drinking water the first half liter ofwater drawn in the morning or after aprolonged period of non-use.• After periods of prolonged non-use, butat least every third day, the fittings mustbe opened with the handle in hot andcold position to prevent stagnation in theconnecting lines. Let the water run until thewater temperature is constant.Installation putty order as an extraSpecial accessoriesspecial tool (58085000) order as an extraSpare parts (see page 38)Flow diagram(see page 36)c with EcoSmart®d without EcoSmart®Dimensions (see page 36)Do not use silicone containing acetic acid!To adjust the hot water limiter on single levermixers, please see page 34. No adjustmentis necessary when using a continuous flowwater heater.Symbol description6 Safety Notes6 Gloves should be worn during installation to preventcrushing and cutting injuries.6 The shower system may only be used for bathing,hygienic and body cleansing purposes.6 The hot and cold supplies must be of equalpressures.Installation Instructions• The fitting must be installed, flushed and tested afterthe valid norms.• If the instantaneous water heater causes problems orif you wish to increase the water flow, the EcoSmart ®(flow limiter) located behind the aerator can beremoved.• Prior to installation, inspect the product for transportdamages.After it has been installed, no transport or surfacedamage will be honoured.Technical DataThis mixer series-produced with EcoSmart® (flowlimiter)Operating pressure: max. 1 MPaRecommended operating pressure: 0,1 – 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 minHansgrohe mixers can be used together withhydraulically and thermically controlled continuous flowheaters if the flow pressure is at least 0,15 MPa.The product is exclusively designed for drinking water!English4