Hans Grohe Metris 31480000 Instructions For Use/assembly Instructions

Also see for Metris 31480000: Instructions for use Instructions for use/assembly instructions Instructions for use/assembly instructions

Contents

installation instructions

Hans Grohe Metris 31480000 Instructions For Use/assembly Instructions Manual pdf 4 page image

Assembly see page 31EnglishSymbol descriptionDo not use silicone containing acetic acid!Adjustment (see page 33)To adjust the hot water limiter. Using a hotwater limiter in combination with a continu-ous flow water heater is not recommended.Operation (see page 34)Cleaning (see enclosed brochure)Dimensions (see page 35)Flow diagram(see page 36)Spare parts (see page 37)Maintenance (see page 39)The check valves must be checked regularlyaccording to DIN EN 1717 in accordancewith national or regional regulations (at leastonce a year).Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The shower system may only be used for bathing,hygienic and body cleaning purposes.The hot and cold supplies must be of equal pres-sures.Installation Instructions• Prior to installation, inspect the product for transportdamages. After it has been installed, no transport orsurface damage will be honoured.• The pipes and the fixture must be installed, flushedand tested as per the applicable standards.• The plumbing codes applicable in the respectivecountries must be oberserved.• The diverter (type HC) installed in the bath mixer isdesigned as an anti-retraction device. For this reason,the lower edge of the diverter must be at least 25 mmabove the highest possible dirty water level.Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 min• Safety against backflow• The product is exclusively designed for drinking water!Fault Cause RemedyInsufficient water - check valve hasn't moved back - Exchange check valves- Shower filter seal dirty - Clean filter seal between showerand hoseMixer stiff - Cartridge defective, calcified - Exchange cartridgeMixer dripping - Cartridge defective - Exchange cartridgeHot water temperature too low - Hot water limiter incorrectly set - Set hot water limiterInstantaneous heater didn’t work - Flow limiter in handshower isn’tremoved- Remove flow limiter- Shower filter seal dirty - Clean filter seal between showerand hose- check valve hasn't moved back - Exchange check valves4Test certificate (see page 40)