Hans Grohe Metris Classic 31078 Series Instructions For Use/assembly Instructions

Also see for Metris Classic 31078 Series: Manual Instructions for use/assembly instructions Assembly instructions Instructions for use/assembly instructions

Contents

installation instructions

Hans Grohe Metris Classic 31078 Series Instructions For Use/assembly Instructions Manual pdf 2 page image

Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.The shower system may only be used for bathing,hygienic and body cleansing purposes.The hot and cold supplies must be of equal pressu-res.Installation InstructionsThe fitting must be installed, flushed and tested afterthe valid norms.If the instantaneous water heater causes problems orif you wish to increase the water flow, the EcoSmart®(flow limiter) located behind the aerator can beremoved.Technical DataThis mixer series-produced with EcoSmart® (flowlimiter)Operating pressure: max. 1 MPaRecommended operating pressure: 0,1 – 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CHansgrohe mixers can be used together withhydraulically and thermically controlled continuous flowheaters if the flow pressure is at least 0,15 MPa.••EnglishCleaning (see page 37) enclosedbrochureOperation (see page 36)Spare parts (see page 38)Assembly see page 31 + 32Dimensions (see page 34 + 35)Do not use silicone containing acetic acid!Special accessoriesspecial tool (58085000) order as an extraInstallation kit order as an extraTo adjust the hot water limiter on single levermixers, please see page 33. No adjustmentis necessary when using a continuous flowwater heater.Symbol descriptionFlow diagram(see page 34 + 35) with EcoSmart® without EcoSmart®Test certificate (see page 39)