Hans Grohe Metris Instructions For Use Manual

Also see for Metris: Instructions for use/assembly instructions Manual Instructions for use/assembly instructions Instructions for use/assembly instructions Instructions for use and assembly instructions

Contents

technical data

4Safety NotesGloves should be worn during installation to preventcrushing and cutting injuries.Children as well as adults with physical, mental and/or sensoric impairments must not use this productwithout proper supervision. Persons under the influ-ence of alcohol or drugs are prohibited from usingthis product.The shower system may only be used for bathing,hygienic and body cleaning purposes.Do not allow the streams of the shower touch sensi-tive body parts (such as your eyes). An adequatedistance must be kept between the shower and you.The product may not be used as a holding handle. Aseparate handle must be installed.The hot and cold supplies must be of equal pres-sures.Installation Instructions• Prior to installation, inspect the product for transportdamages. After it has been installed, no transport orsurface damage will be honoured.• The pipes and the fixture must be installed, flushedand tested as per the applicable standards.• The plumbing codes applicable in the respectivecountries must be oberserved.• The premounted filter insert must be used to ensurea normal flow of the shower and to prevent dirt fromentering through the pipes. Dirt entering can affect thefunction and/or lead to damages to the shower. Hans-grohe will not be held liable for this type of damage.EnglishDo not use silicone containing acetic acid!Maintenance (see page 37)The check valves must be checked regularlyaccording to DIN EN 1717 in accordancewith national or regional regulations (at leastonce a year).Symbol descriptionAdjustment (see page 33)To adjust the hot water limiter. Using a hotwater limiter in combination with a continu-ous flow water heater is not recommended.Cleaning (see page 38) and en-closed brochureOperation (see page 36)Flow diagram(see page 35)c Hand showerd Bath SpoutDimensions (see page 34)Spare parts (see page 39)Assembly see page 31Technical DataOperating pressure: max. 1 MPaRecommended operating pressure: 0,1 - 0,5 MPaTest pressure: 1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CThermal disinfection: max. 70°C / 4 minSafety against backflowThe product is exclusively designed for drinking water!